Sun System Sun Hoist Manual

Grow Light Lift Kit
The Sun Hoist Wireless Light Lift System is designed to control
a total lighting load of not more than 60 pounds. Ensure that the
light, ballast (if required) and any hood vent hardware DOES NOT
EXCEED 60 pounds total.
SUN HOIST KIT COMPONENTS
• 1 each Sun Hoist Lift Motor
• 1 each Power Supply
• 1 each Mounting Rail with 2 screws
To operate your Sun Hoist
Wireless Light Lift System
you will need to download the
MySmartLift application. Go
to Apple Store or Google Play
Store to download. There is no
cost for the MySmartLift app.
INSTALLATION
Install the mounting rail
1
in a suitable location above
the desired area with the
screws provided.
Use template printed at the
end of these instructions for
hole placement.
MOUNTING RAIL TEMPLATE
4.00 in
It is the users' responsibility
to ensure that the support
used is adequate to bear
the weight of the Sun Hoist
System and associated
hardware.
Congratulations on your purchase of a state of the art Sun Hoist
Wireless Light Lift System! To ensure that you get the most out of
your Sun Hoist Wireless Light Lift System, please read these instructions
completely and carefully BEFORE installing or operating your system.
• 1 each Auto Level Sensor
with Cord
Do not exceed
a total weight
of 60 pounds
all components.
Slide Sun Hoist onto rail
2
and tighten thumbscrew to
anchor. Do not over-tighten.
TIGHTEN
THUMBSCREW
The Sun Hoist has an auto-
3
leveling feature that uses a
magnetically mounted sensor
mounted to the top of the
grow light. IMPORTANT: The
level sensor must be mounted
Watch this Sun Hoist
Installation Video after
reading these instructions.
parallel to the front and
back edges of the grow light
housing. ALSO, the sensor
unit logo must be to the front,
with the cord connection on
for
the left side. See Fig 1.
Plug the sensor coil cord
4
into the sensor and into the
corresponding port
on the Sun Hoist labeled
Auto Level Sensor.
Double check the position
of the level sensor and cord
connection for accurate
operation. See Fig 1.
Attach one end
5
of the power
supply to the
Sun Hoist port
labeled Power
Port.
™
QR
CODE
FIG 1.