Advertisement
Sync Out, Sync In
Synchronization output and synchronization input for master slave configuration of
capturing multiple parallel channels.
Pin
1. Tip
2. Ring
3. Sleeve
Status LEDs
LED operations of UCD devices are firmware dependent and subject to change excluding
power good which is always available. Functions for each LED are described in the figure
below.
UCD-2 Vx1
LED
1, 3, 9, 11
2, 4, 10, 12
6, 8
7
5
The table below shows the pin-out of one connector. Please refer to chapter
Source Devices
Channel A is for the data of ODD and Channel B of EVEN pixels. N/C = No Connection
Description
Signal 1
Signal 2
Ground
Description
On = V-by-One symbol lock
Flashing = FW running
On = Power good
For chained devices: On = Master, Off = Slave
Unused
later in this document on allocating data to the two connectors.
50
GND
Signal Ground
51
N/C
N/C / Not in use
7
Connecting
Advertisement
