Summary of Contents for Gira DALI Tronic Trafo 105 W
Page 1
DALI Tronic transformer 105 W DALI Tronic transformer 105 W Order-No. : 2380 00 Operating instructions 1 Safety instructions Electrical equipment may only be installed and fitted by electrically skilled persons. Failure to observe the instructions may cause damage to the device and result in fire and other hazards.
DALI Tronic transformer 105 W i Flickering of the connected lamps is possible if the load is below the specified minimum. This does not represent any defect in the device. Behaviour after mains voltage failure in operation with DALI control unit The behaviour is dependent on the DALI control unit.
Page 3
DALI Tronic transformer 105 W All transformers switch off. Make a long press on the installation button. All transformers switch on to minimum brightness. i If the installation button is still pressed, the light becomes brighter up to maximum brightness. 5 Information for qualified electricians 5.1 Fitting and electrical connection DANGER!
Page 4
DALI Tronic transformer 105 W Cable recommendations for reliable strain relief Primary side Secondary side H03VV-F 2×0.50mm H03VV-F 2×0.75mm H03VV-F 2×0.75mm H05VVH2-F 2×0.75mm H03VVH2-F 2×0.75mm H05VV-F 2×1.5mm H05VVH2-F 2×0.75mm H05VV-F 2×2.5mm NYM-J 3×1.5mm NYM-J 3×1.5mm NYM-O 2×1.5mm NYM-O 2×1.5mm NYM-J 3×2.5mm Figure 3: Stripping lengths Strip connecting cables according to specifications (Figure 3).
Page 5
DALI Tronic transformer 105 W Connecting transformer with DALI control unit Figure 4: Connection diagram with DALI control unit Connect transformer (5) and DALI control unit (4) according to connection diagram (Figure 4). i The connected transformers and the DALI control unit may be operated on different outer conductors.
DALI Tronic transformer 105 W 5.2 Commissioning Commissioning with DALI control unit Commissioning depends on the control unit being used. The system is fitted and connected. Switch on mains voltage. Transformer switches to maximum brightness. Perform commissioning (see instructions for control unit) Commissioning with installation button The system is fitted and connected.
The warranty is provided in accordance with statutory requirements via the specialist trade. Please submit or send faulty devices postage paid together with an error description to your responsible salesperson (specialist trade/installation company/electrical specialist trade). They will forward the devices to the Gira Service Center. Gira Giersiepen GmbH & Co. KG...