Advertisement
Quick Links
UNIVERSAL LIGHT WEIGHT PLOW - RIDING MOWER
PLOW ASSEMBLY
MOWER ADAPTER ASSEMBLY
PLOW ATTACHMENT TO MOWER
ANGLE PLOWING ADJUSTMENTS Step:
ASSEMBLY INSTRUCTIONS
Steps:
Steps:
11
Steps:
13
Nordic Auto Plow LLC
771 W. North Ave.
West Chicago IL 60185
Phone for customer service: 888-662-PLOW (7569)
E-mail: support@nordicautoplow.com
Website: nordicautoplow.com
866-941-6577 (Fax)
1
2
3
4
8
9 10
12
5
6
7
Advertisement
Summary of Contents for Nordic Auto Plow 18550
- Page 1 Steps: 9 10 MOWER ADAPTER ASSEMBLY Steps: PLOW ATTACHMENT TO MOWER Steps: ANGLE PLOWING ADJUSTMENTS Step: Nordic Auto Plow LLC 771 W. North Ave. West Chicago IL 60185 Phone for customer service: 888-662-PLOW (7569) E-mail: support@nordicautoplow.com Website: nordicautoplow.com 866-941-6577 (Fax)
- Page 2 PLOW ASSEMBLY PARTS: BLOCK TOP PIVOT PLATE BOTTOM PIVOT (8 - PIECES) (1 - PIECE) PLATE (1 - PIECE) BLADE SECTION BLADE END BLADE CHANNEL (3 - PIECES) (2 - PIECES) PLOW STRAP (2 - PIECES) (1 - PIECE) MOWER ADAPTER ASSEMBLY PARTS: MOWER ARM (2 - PIECES) BOOT PLATE...
- Page 3 LOCKING FACES OF LOCK NUTS MUST ALWAYS BE IN IMPORTANT! AGAINST THE SURFACE YOU 1” LONG TIGHTEN FULLY ARE FASTENING! A A A A A A A A A A A A A A A A A A A A A A A A A Place the Blade Sections face down and slide together as shown.
- Page 4 NOTE: SLOT ON TOP OF PLOW BLADE CHANNEL (SMALL FLANGE Slide a Blade Channel (smaller flange at the top) over the top (4) protruding bolt ends. Secure parts with (4) Keps nuts as shown. BLADE CHANNEL (SMALL FLANGE DOWN) Slide a Blade Channel (smaller flange at the BOTTOM) over the bottom (4) protruding bolt ends.
- Page 5 LOCKING FACES OF LOCK NUTS MUST ALWAYS BE IN AGAINST THE SURFACE YOU ARE FASTENING! 1’ HEX HEAD BOLTS (FROM INSIDE) REMOVE THE FRONT BUMPER (IF MOWER IS SO Using either side or end of the Mower Arm, slide EQUIPPED). Feed (2) 1” hex head bolts through it over the bolts and secure with (2) lock nuts.
- Page 6 PIVOT BRACKET For the (2) holes closest to the Mower: Use the 1/2” x 1’ long bolts, nylon insert lock nuts, with washers positioned as shown, and secure PIVOT PLATES from underneath as shown. Do not tighten fully, ATTACHED TO but allow parts to pivot freely.
- Page 7 DISCHARGE TO LEFT DISCHARGE TO RIGHT STRAIGHT PLOWING T-HANDLE QUICK RELEASE PINS PLOWING ANGLE SETTINGS ARE SHOWN ABOVE. For plow discharging to the LEFT or RIGHT of the operator rotate the plow as shown, line up holes in the Pivot Brackets with the hole in the Pivot Plate, feed T - Handle Quick Release Pins through the appropriate holes.