SHERCO 6202 Installation Manual

Subject: 2 Stroke fan installation guide
Motocyclette/Motorcycle/Motocicleta
50 2T
This technical note guides you to mount the electrical fan ref. 6202 compatible with 2 strokes
SHERCO bikes.
1. Make sure the power bouton is switched off. Remove the seat and the gas tank with
the radiator shrouds.
2. Drain the coolant out of the bike by removing the drain plug on the water pump
located on the right side of the engine (see owner's manual).
3. Unbolt the 3 hoses of the right radiator. Unbolt the right radiator from the bike,
disconnect the hoses and remove the radiator. Be careful not to damage the fins on the
radiator.
4. Drill a 4 mm hole on each side of the radiator at a distance of 16 cm from the top.
5. Place the fan mounting bracket on the radiator and drill the others 4mm holes
necessary to fix fan.
6. Screw the bracket to the holes on the inside and outside edges of the radiator using the
supplied self-tapping screws. Use a T20 Torx driver. Recommended torque is 2.5 Nm.
7. To compensate the influence of ambient air passing across the sensor, apply thermal
grease (included in kit) into the gap between the fins of the radiator where the sensor
will be installed. It is important to place the grease only in the gap. Grease on the
surface of the radiator will attract dirt and reduce function.
8. Carefully insert the temperature probe into fins of radiator. Make sure that the probe is
lined up parallel to the fins to avoid damage.
Technical information
250/300 2T
www.sherco.com
www.sherconetwork.com
250/300 4T
Document nº
NT 85-01
Date/Fecha
16/09/2015
450 4T