Advertisement
‰ ‰ DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.
‰ 8
‰ ‰ DO NOT touch the heater casing or grill when first switched off, as these will be very hot and will take time to cool.
‰ 8
‰ ‰ DO NOT use the heater for anything other than its intended purpose. It is designed to provide heat in enclosed areas larger than 4m
‰ 8
such as workshops and other industrial areas. It is not suitable for drying clothes or laundry.
‰ ‰ DO NOT place the heater close to a bath, wash basin, shower, swimming pool or any other water-filled area or wet surface.
‰ 8
DO NOT get the heater wet or use in areas of high condensation.
8
‰ ‰ DO NOT place the heater up against any surface such as a wall, door or furniture etc.
‰ 8
‰ ‰ DO NOT place the heater immediately below any electrical outlet.
‰ 8
‰ ‰ DO NOT allow the power lead to touch the radiator surface.
‰ 8
NOTE: Children of less than 3 years should be kept away unless supervised continuously.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended
normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user
maintenance.
CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable
people are present.
NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
2. INTRODUCTION
Electric fan heater for industrial applications. Two heat settings with thermostat control, plus fan only setting. A totally dry heat with no
Condensation, no gas, no fumes, so no smell. Ideal for workshops, garages etc.
3. SPECIFICATIONS
Model: ...................................................................... EH3001
Voltage: ..........................................................................230V
Power rating: ...............................................................3000W
Heat Settings: .................................................1500W/3000W
Dimensions (W x D x H): .........................315 x 330 x 400mm
Fuse: ................................................................................16A
IMPORTANT! This unit is designed to raise the ambient temperature of an entire room, the temperature of the air coming out of the front of
the heater will be warmer than the general temperature of the room, but there may not be a significant increase due to the large volume of air
passing over the element. For the same reason, the element is hot during operation, but does not glow visibly. The room temperature depends
on room size, insulation and the ambient temperature, which will increase as the room gets warmer.
4. OPERATION
4.1.
Position heater in an upright position on a firm surface and at a safe distance from any obstructions, flammable substances etc. Keep
to a minimum of 0.5mtr clearance at the rear and sides, and 2mtr clearance at the front.
4.2.
Connect the heater to a suitable mains supply.
4.3.
Set the thermostat dial to the maximum setting (fully clockwise).
4.4.
The heater will switch on when the power setting selector is set to one of the two power settings.
NOTE: It will take up to three minutes for the heater to reach optimum temperature.
4.5.
Once the room reaches the required temperature, turn the thermostat dial slowly counter-clockwise until the thermostat clicks, leave
the dial in this position and the room temperature will be maintained at this setting. The heater will continue to operate until the power
switch is turned to the OFF position.
4.6.
For fan only operation, turn the power/fan selector to the fan only setting and set the thermostat to its minimum setting.
4.7.
When not in use, disconnect the heater from the mains supply. Store it in a safe, dry, childproof location.
© Jack Sealey Limited
Original Language Version
EH3001| Issue: 6(ERP) - 20/06/18
,
³
Advertisement
