Corby System 2000 Instructions

Setup Remote Courier V.Everything Modem for Network Interface Controller (NIC)
Step 1. Set the DIP switches located at the bottom of the modem as in the table below.
1 2
Ignore Verbal
DTR Result
Codes
ON ON
down down
Step 2. Connect Modem to a Computer serial port. This is Com1, Com2, Com3, or Com4.
Step 3. Start the program HyperTerminal. Find this under your Start Programs menu. It may be under
Accessories or Communications.
Step 4. When you start HyperTerminal, a window will open asking you for the name and icon of a new
connection.
* Select 'Cancel'.
* Under 'File', select 'Open'.
* Change the 'Look in' folder to be where your System 2000 Modems folder is located.
(For example: C:\Program Files\Corby\Sys2000\Modems).
* Double-click on the file 'Setup on Comx' where 'x' is the com port the modem is connected to.
(The port is now configured for 115,200 baud, 8 data bits, no parity bit, 1 start bit, and hardware flow
control.)
Step 5. Still in HyperTerminal, do the following:
* Under 'Transfer', select 'Send Text File'.
* Double-click on the file 'Nic Modem Setup.txt.
Step 6. Reset your modem by turning power off and on. Disconnect modem from computer and install with the
System 2000 NIC. Be sure to use a Null Modem adapter (or Null Modem cable) between the System
2000 NIC and Modem. The easiest way to tell if you have the correct cable is by looking at the LEDs on
the NIC. If the CTS and/or DCD LEDs are on with the cable connected to the modem (and the modem is
powered up), then your cable is incorrect, and you need to insert a Null Modem Adapter between the NIC
and Modem. Connect the phone line to the modem 'JACK' connector.
Step 7. Go to System 2000 PC Modem Setup (see below). You may leave HyperTerminal running.
Corby Industries, Inc.
1501 E. Pennsylvania Street, Allentown, PA 18109
http://www.corby.com
(800) OK-CORBY (610) 433-1412
Fax (610) 435-1963
3 4
Display Disable
Result Echo
Codes
OFF ON
up down
System 2000 Modem Instructions
for 3 Com Courier V.Everything M odems Page 1 of 2
5 6
Disable CD On Originate
Auto
Answer
OFF OFF
up up down
7 8
Enable AT
Mode Commands
ON ON
down
p/n 2300, Last Updated on December 13, 2001
9
10
Command Load
Mode on Factory
+++ Settings
ON OFF
down up