Advertisement
Quick Links
Setup Instructions
STANDROID
Identifying Parts (Monitor Not Included.
A - Vertical Supports (x2)
E - Base w/ Mounting Posts
I - T-Bolt for Monitor
(size M4, M6, or M8, x2 ea.)
M - Tension Wire
Q - Case*
B - Hand Tool
F - Fabric (Black or Printed*)
J - Leveling Bolt for Monitor
(size M4, M6, or M8, x2 ea.)
N - Hover Frame*
R - Case-to-Counter Wrap
(Black or Printed*)
*Optional
Upgrades)
C - Top/Bottom Supports (x2)
G - Monitor Profile Bar
K - Eye Nut w/ Wing Bolt
O - Hover Graphic*
S - Case-to-Counter Top
D - Cross Supports (x3)
H - T-Bolt w/ Wing Nut (x2)
L - Eye Bolt
P - Hover Frame Arms
w/ Wing-Nuts* (x2)
Advertisement
Summary of Contents for Okuma STANDROID
- Page 1 Setup Instructions STANDROID Identifying Parts (Monitor Not Included. *Optional Upgrades) B - Hand Tool C - Top/Bottom Supports (x2) D - Cross Supports (x3) A - Vertical Supports (x2) F - Fabric (Black or Printed*) G - Monitor Profile Bar...
- Page 2 Setup Instructions STANDROID Frame and Fabric Connecting the Frame 1. Connect 3-part Vertical Supports (A) with plastic grommets facing out. 2. Using the Hand Tool (B), attach the top and bottom Horizontal Supports (C) to the Connecting Vertical Supports (A) by turning the screw Corners with the star-shaped hole clockwise.
- Page 3 Setup Instructions STANDROID Frame and Monitor Connecting the Frame to the Base (E) 1. Slide assembled Frame and Fabric (with graphic facing forward to the long side of the base) onto protruding the posts of the Base (E). Attaching and Securing the Monitor 1.
- Page 4 Setup Instructions STANDROID Frame and Hover Graphic Securing the Leveling the Frame 1. Attach the Eye Nut with Wing Bolt (K) through the hole in the center of the top Horizontal Support (C). 2. Attach the Eye Bolt (L) to the base at the screw hole insert located at the back.