Advertisement
Advertisement
Table of Contents
Summary of Contents for luxvision ET-4000
- Page 1 USER'S MANUAL...
- Page 2 [ELD Electric Lift System Chart] ELB-A Controller 1 Set ELH-A Manual Controller 1 Pcs 3 Pins European Type Power Cord 1 Cable ELD-A Vertical Shaft 2 Sets Patch Cord 2 Cable Diagram 1 [Technology Parameter] Input: 230V AC or 120V AC Output Power: 24V DC Load Capacity:...
- Page 3 [Setup Procedures] 1. Referring to Diagram 1, connect both ELD-A Vertical Shafts to the ELB-A Controller via the supplied Patch Cords. Next connect the ELH-A Manual Controller (refer to Diagram 2) and supplied Power Cord to the ELB-A Controller. 2. In line with controller name plate, plug the controller into the electricity supply (either 230V AC or 120V AC).
- Page 4 (1) If either of the Vertical Shafts detects an abnormal situation the Manual Controller will display an error message on the digital display (See Notes below for error messages). Depress the “DOWN” key for 5 seconds. The Vertical Shaft will descend. Depress the “DOWN” button again to complete the reset process.
- Page 5 3. If any problems occurred, please contact the supplier immediately. [Warranty] 1. Within the warranty period of one year from the date of purchase, we’re responsible for the trouble shooting due to the product quality under normal usage; 2. Please do not open the products by yourself. Warranty service shall be deemed to be waived by non-authorized opening.
Need help?
Do you have a question about the ET-4000 and is the answer not in the manual?
Questions and answers