Page 2
Contents of the pack No.1 heat meter consisting of: detachable electronic unit, volume meter, two temperature probes. All these parts are permanently connected to each other. No.1 instruction sheet for installation. No.1 sealing kit for flow probe and hydraulic section. No.2 3/4’’...
Page 3
Installation – Volume meter Close the upstream and downstream shut-off valves nearest to the point where the SENSONICAL ULTRA heat meter is to be installed. Open the nearest drain valve to decrease the pressure. Remove and empty the tube portion where the hydraulic section of the SENSONICAL ULTRA is to be installed.
Page 4
Installation diagrams CAL1918 series ultrasonic heat meter Probe holder ball valve for SENSONICAL ULTRA Circulation pump Three-way valve Ball valve Balancing valve Check valve Strainer NB: Failure to observe these instructions proper installation impair operation invalidate warranty. Display readings and information The electronic unit is equipped with a liquid crystal display with 8 digits and special characters.
Page 5
3 Date of last readout alternating with relative heating/cooling energy consumption and pulse input meters 4 Total volume in m 5 Instantaneous power in kW 6 Instantaneous flow rate in m 7 Current date in format DD.MM.YY 8 Error Message (alternating binary and hexadecimal displaying) 9 Not used 10 Not used...
Page 6
Temperature difference Days of operation since setting Probe model and installation position (R=return, U=inlet) M-bus address Serial number of the heat meter 10 Firmware/software release 3 - Statistical level Date of last readout alternating with relative heating/cooling energy consumption and pulse input meters 2-16 Monthly values: date of last reading alternating with relative heating/cooling energy consumption and pulse input meters available on CAL19185MI...
Page 7
Position Error indicator Description Hexadecimal code “1” in position 1 Low battery “1” in position 2 Check-sum error “1” in position 3 PROM error “1” in position 4 Reset “1” in position 5 Coil error “1” in position 6 Reference probe failure “1”...
Page 8
Data transmission interface The instrument is not powered by the M-Bus interface and is equipped with galvanic isolation. In a M-bus network with a maximum of 250 instruments, it is possible to perform 24 readouts a day for each instrument. If fewer readouts are carried out and/or if the number of instruments installed in the network (connected to the M-Bus system) is lower, any unused requests will be stored in the instrument to be used when needed.