Do you have a question about the 3425 and is the answer not in the manual?
Questions and answers
Summary of Contents for Gymnova 3425
Page 1
XTENSIONS 3427 info@gymnova.com Fixation on the ground (Ref.: 3427) Fixation on wall (Ref.: 3426) Fixation between ground and wall (Ref.: 3425) Take care of precautions for STORAGE In case of problem, phone to our technical service : +33.4.91.87.51.20 Warning : This equipment must be installed by a qualified person.
Page 2
I . F .: 3427) LOOR MOUNTED FOLDING EXTENSION 1.1. Preparing and mounting the low swivel plate (8) to the floor: 1 – Trace the position (P) of the slide pivot (7) on the ground, and the axes for the bracing mounts, as shown in figure 1. 2 –...
Page 3
II . W .: 3426) ALL MOUNTED FOLDING EXTENSION 2.1. Preparing and mounting the wall plates (14): 1 – Trace a vertical line on the wall as shown in figure 4. 2 – To position the top plate at height "A", take height "H" as shown in the table in figure 5 (Check that the wall is perpendicular: can lock the verticality of the 2 plates).
Page 4
III . F .: 3425) LOOR WALL MOUNTED FOLDING EXTENSION 3.1. Preparing and fastening the low pivot (8) to the floor and the wall plate (14): 1 – Trace the position (P) of the slide pivot (7) on the floor as shown in figures 7 and 8 (Make sure the wall is perpendicular: 100 mm offset from the line of the top plate).
Page 5
Precautions for storing the Table It is essential not to put anything on the body: its dynamic structure (internal) and the curve of the take-off zone (external) could be irreversibly damaged (Do not sit on it either !!!). When it is dismantled: - Never lay it on the front tip, - Store it preferably upside down or on its side.
Need help?
Do you have a question about the 3425 and is the answer not in the manual?
Questions and answers