Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Shut off the engine, engage the parking brake,
and remove the key from the ignition switch.
3.
Disconnect the battery; refer to the electrical
system maintenance section of your Operator's
Manual.
2
Removing the Sunshade
No Parts Required
Procedure
1. Sunshade
1.
Remove the 4 flange-head bolts (5/16 x 1-1/4
inches) and 4 washers (5/16 inch) that secure
the sunshade to the side-frame channels
1
and
Figure
2).
Note:
Do not remove the grommets from the
sunshade.
Figure 1
1. Grommet
2. Flange-head bolt (5/16 x
1-1/4 inches)
2.
Remove the sunshade from the machine
1).
3
Preparing the Switch Panel
Parts needed for this procedure:
1
Decal
1
Switch panel
Installing the Decal to the Switch
g244329
Panel
1.
Carefully remove the backing from the decal
(Figure
(Figure
2
Figure 2
3. Washer (5/16 inch)
4. Clip nut (side-frame
channel)
3).
g244328
(Figure
Advertisement
