Advertisement
3. PrePArAtion
ADAPtor blockS
3.1.
The MS070 includes adaptors (fig 1).
3.2.
Use the adaptors to ensure that the MS070 is set up accurately.
3.3.
Place the adaptor blocks against each side of the wheel rim (fig 2).
4. Set uP
laser Power: The laser units are battery powered and require two AA batteries in each battery box. See fig.4.
4.1.
4.2.
Slide back the lid on each box and insert the batteries paying attention to the polarity markings in the base of each box. Slide the
lids back into position on each battery box.
4.3.
ensure the laser units are working by switching on with the units directed to the ground. Switch off after testing.
4.4.
Assembly: Identify the laser unit with the threaded insert in the side and screw one of the threaded rods supplied into the insert.
Identify the scale unit with the threaded insert in the side and screw the other threaded rod into place.
4.5.
Motorcycle stability: Before attaching the laser and scale units you must ensure that the motorcycle is adequately supported on a
suitable stand that lifts the rear wheel from the ground and supports the motorcycle in a perpendicular orientation. The stand must
also be on a firm stable surface such as concrete.
4.6.
Attaching the laser units to the rear wheel: Referring to fig.3, loosen the clamp and remove the clamp unit and spring from the
rod together with the right hand laser unit. Position the left hand laser unit with the rod attached on the nearside of the
rear wheel and insert the rod through the adaptor and then through the lower part of the wheel. Slide the right hand adaptor and
laser unit onto the rod and up to the tyre, followed by the spring and clamp unit. Clamp the two units lightly to the wheel using the
adaptors on the wheel rim to space the laser unit away from the tyre in the position indicated in fig.4.
fig.3
© Jack Sealey limited
fig.1
Key
1. left laser Unit
2. Right laser Unit
3. Threaded Rod
4. Clamp and Spring
5.Threaded Bush
6. Adaptors
7. on/off Switch and light
8. Battery Box
9. Calibration Shield
Original Language Version
fig.2
fig.4
MS070.V2 Issue 2 (H4F) 25/05/18
Advertisement
