2.4 Mobile Device Control and Status Report
2.4.1 +CPAS: check module's status
Description
This command is used to check the module's work status.
Format
AT+CPAS
Example
AT+CPAS
+CPAS:2
OK
Parameter
<pas>
0:
2: Unknown status (default)
3: Incoming call (ring)
4: In a call
<pas>:
2.4.2 +CFUN: set module's function
Description
This command is used to enable/disable some functions of the module.
Format
AT+CFUN=<func>,<rst>
Example
AT+CFUN=?
+CFUN(1,4),(0-1)
OK
AT+CFUN=1,0
AT+CFUN=1,1
Parameter
<fun>
1
4
<rst>
0
1
2.4.3 +CMEE: mobile equipment errors
Description This command is used for mobile equipment's error report.
Format
AT+CMEE=<n>
Example
AT+CMEE?
AT+CMEE=<n>
Ready to receive AT command
Full function (default)
Disable RF Tx. and Rx. Function
valid after settings
valid after restart
Check the module's current work
status.
Check the setting range
Settings validate, invalid after reset
Settings valid after reset
+CMEE:<n>
OK
Check current error report method
OK
Select error report method
28
GSM Module