Advertisement
Quick Links
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
Instruction No
Instruction No
Version
Version
30660544
30660544
1.0
1.0
© Volvo Car Corporation
Part. No.
Part. No.
Accessory Electronic Module (AEM)
Accessory Electronic Module (AEM)
Accessory Electronic Module (AEM)- 30660544 - V1.0
Page 1 / 21
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Volvo AEM
- Page 1 Volvo Car Corporation Gothenburg, Sweden Instruction No Instruction No Version Version Part. No. Part. No. 30660544 30660544 Accessory Electronic Module (AEM) Accessory Electronic Module (AEM) © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 1 / 21...
- Page 2 Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Equipment A0000162 A0000163 A0000161 A0801178 M3703516 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 2 / 21...
- Page 3 Turn the ignition switch to position 0. Disconnect the battery negative lead. Note! Wait at least five minutes before disassembling the connectors or removing other electrical equipment. A8800136 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 3 / 21...
- Page 4 Then pull the panel straight up until the four clips in the bottom edge release. Remove the wiring (5) for the cargo compartment lighting. Lift out the sill trim panel. D8505031 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 4 / 21...
- Page 5 Remove the Rear Electronic Module (REM) by opening the lock (1) on the top of the unit. Tip the unit forward and lift it out of the mountings (2). D3703404 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 5 / 21...
- Page 6 Carefully prise apart the sides of the connector holder in the ends so that the connector can pass by the retaining hooks. Pull out the connector. D3703496 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 6 / 21...
- Page 7 Press in the catch on the grey connector on the rear of the fuse holder in the cargo compartment, turn the lock arm up as far as it will go and pull out the connector. M3904942 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 7 / 21...
- Page 8 Connect the white (W) cable to position 30. Reinstall the connector in the holder Reinstall the connector in the fuse holder. Refit the Rear Electronic Module (REM). R3703511 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 8 / 21...
- Page 9 Detach the bracket and treat the edges of the holes using a rust- proofing agent. Tighten the bracket to the side member. Tighten the rear bolt/nut to 10 Nm (8 lbf.ft.) . M3702506 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 9 / 21...
- Page 10 Reconnect the battery negative lead Reposition the folding panels and refit the cargo compartment carpet. Program the software according to the service information in VIDA. Applies to the V70 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 10 / 21...
- Page 11 A8800136 Remove both the floor hatches. First lift the rear edges of the floor hatches slightly. Then pull the hatches backwards from their mountings. M8502718 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 11 / 21...
- Page 12 90°. Lift out the box. M8503121 Remove the left folding panel from the cargo compartment. Repeat the operation on the other side. M8502710 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 12 / 21...
- Page 13 Fold the panel inwards. Lift the panel out. Repeat the operation on the other side. M8503130 Remove the insulation panel from the cargo compartment. M8503245 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 13 / 21...
- Page 14 Remove the 4 x screws in the tailgate sill panel. M8503123 Remove the three screws (1) from the right-hand floor support Remove the floor support. M8505041 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 14 / 21...
- Page 15 Take four cable ties (2) from the kit and secure the wiring harness to the existing wiring harness as illustrated. Press the sill panel into place. Reinstall the screws in the panel. Tighten. M3703514 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 15 / 21...
- Page 16 Press in the catch on the rear brown connector in the fuse holder in the cargo compartment, turn the lock arm up as far as it will go and pull out the connector. M3904943 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 16 / 21...
- Page 17 Pull out the connector. D3703496 Connect the red (R) cable to position 22. Reinstall the connector in the holder Reinstall the connector in the fuse holder. R3703512 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 17 / 21...
- Page 18 Carefully prise apart the sides of the connector holder in the ends so that the connector can pass by the retaining hooks. Pull out the connector. M3703366 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 18 / 21...
- Page 19 Reinstall the connector in the fuse holder. Refit the Rear Electronic Module (REM). R3703511 Fit fuse 15A from the kit in position 3 on the fuse holder. M3703370 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 19 / 21...
- Page 20 M6-screws, tightening them to 10 Nm (8 lbf.ft.). Position two new spacer washers between the front hole in the bracket and the floor support. Tighten using a new self tapping screw. M3702508 © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 20 / 21...
- Page 21 Reinstall the panels. Refit the insulation panel. Reinstall the storage box. Reinstall both floor hatches Program the software according to the service information in VIDA. © Volvo Car Corporation Accessory Electronic Module (AEM)- 30660544 - V1.0 Page 21 / 21...
Need help?
Do you have a question about the AEM and is the answer not in the manual?
Questions and answers