Nora Lighting NX-605 Installation & Operation Instructions

DIE CAST LED EXIT SIGN
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
1.
2. Review the diagrams thoroughly before beginning. If you feel you do not have electrical wiring
experience, refer to a do-it-yourself wiring handbook or have your fixture installed by a qualified
licensed electrician.
3. All electrical connections must be in accordance with local codes, ordinances, and the National
Electric Code.
services of a qualified licensed electrician.
4. Before starting the installation, disconnect the power by turning off the circuit breaker or by
removing the appropriate fuse at the fuse box. Turning the power off using the light switch is not
sufficient to prevent electrical shock.
5. Do not use outdoors.
6. Do not let power supply cords touch hot surfaces.
7. Do not mount near gas or electric heaters.
8. Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is
spilled on skin or in eyes, flush acid with fresh water and contact a physician immediately.
9. Equipment should be mounted in location and at heights where it will not readily be subject to
tampering by unauthorized personnel.
10. The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
11. Do not use this equipment for other than intended use.
12. All servicing should be performed by qualified personnel only.
13. Allow battery to charge for 24 hours before first use.
If you are unfamiliar with methods of installing electrical wiring, secure the
SAVE THESE INSTRUCTIONS
Rev.040102
Page 1