Wilson Electronics WT16 Assembly Instructions

H. Wilson Company
555 West Taft Drive
South Holland IL 60473
Phone: (800) 245-7224
sales@hwilson.com

DRAWER PARTS LIST:

1. (1) Left Bracket
2. (1) Right Bracket
3. (2) Side panels (L & R)
4. (1) Front Panel w/handle
5. (1) back panel
6. (1) Bottom Panel
7. (2) Extension Rails & Screws
8. (17) Drawer Screws
***READ INSTRUCTIONS BEFORE BEGINNING ASSEMBLY
***USE POWER DRILL IF POSSIBLE
THE EXTENSION RAIL NEEDS TO BE
DISASSEMBLED
FOR INSTALLATION. Extending the rails as far as
possible & push the black lever right to left, then
pull the two pieces apart. (Figure 1)
STEP 1: Place bottom of drawer on flat surface, flat side up.
STEP2: Attach back panel to bottom panel matching the wider lip
of the panel to the bottom and the thinner lip is facing what will
be the outside of the drawer. (Diagram right). Attach side and
bottom panel from underneath with screws (direction of lower
arrow shown right)
STEP 3: Attach brackets to underside of top shelf as shown in
figure 3 (right)
STEP 4: Attach 1/2 of rail assembly without the black lever to
brackets as shown in figure 4 below.
Figure 4
STEP 5 - Attach 1/2 of rails with black lever to assembled drawer as
shown right.
STEP 6 - Fit rails together to slide drawer underneath shelf

CART PARTS LIST:

1. (1) shelf with handle
2. (1) bottom shelf with caster inserts
3. (4) legs
4. (4) 4" casters, two with brake
Back of shelf
ASSEMBLY INSTRUCTIONS
Tuffy Seat With Drawer
Figure 1
Side & back panels will fit to the bottom panel
following the direction of the arrow left.
Bottom panel
Attach with screw from underneath
Figure 3
Figure 3
Back of Drawer