Mathmos Space Projector Instructions

ENGLISH:
The Space Projector is a CLASS
lt has passed the relevant safety standards and carries the statutory guarantee of the country of purchase.
The Space Projector is not intended for use by children.
PLEASE READ ALL THE INSTRUCTIONS BEFORE FIRST USE AND RETAIN FOR FUTURE REFERENCE.
SIide Carrier Slot
SIide Carrier
Focusing Lens
Projector Body
SET UP:
Unpack projector and place upright on a stable surface.
Unpack the wheel and Insert into the wheel slot with the
Plug in at the socket and switch on.
DO NOT: block the ventilation slots in the transformer.
DO NOT: place on carpets or block the ventilation spaces in the projector base.
DO: insert the wheel into the correct side of the projector body as shown
DO: insert the wheel until a light click is feit and the oil wheel is
DO: place the transformer on its feet.
OPERATION:
Angle the projector body to point at the wall or
The best effect is achieved on a white surface.
The brightness and size of the image are controlled by the amount of light in the room and the distance from the wall.
Screw the focusing lens in or out to obtain the best effect.
The effect will change as the oil wheel warms up. lt is
DO NOT: look directly into the focusing lens •
DO NOT: leave unattended with small
DO NOT: use for more than six hours in any one session.
DO NOT: shake the oll wheel.
DO NOT: leave the oil wheel exposed to direct sunlight.
DO: use only when fitted to its base and placed on a level
DO: unplug the transformer from the mains socket when not in continuous
ACCESSORIES:
Other effects are possible by obtaining Mathmos Space Projector upgrade packs from your Mathmos stockist.
The slide carrier is for use with these packs and when not in use can be stored in the slide carrier slot.
DO NOT: attempt to use standard photographic slides in the Space Projector.
DO: use only Mathmos Space Projector effect and accessories.
MAINTENANCE:
SULB NOT WORKING
Should the bulb not light,
lf the light is still not on you
Should the problem persist, contact your nearest Mathmos dealer.
INSTRUCTIONS
II Electrical Product (12V SELV) connected to a Class
Wheel Slot
Base
ceiling.
children.
first check that the plug fuse is working (where fitted), if not replace with a 3A fuse.
will need to change the bulb.
�o
Wheel
Transformer
logo facing the focusing lens.
.
central in the projector.
normal for the wheel to get hot.
surface, (any other orientation will cause
use.
II power supply.
Art.Nr.1424401
1805101
Oil Wheel is central
in Projector
overheating).
1