Race Ramps RR-STR Instructions

Race Ramps Super-Duty Service Ramps
TM
Part #: RR-STR
Made in the USA

General Guidelines

• It is the user's responsibility to read and follow all instructions.
• Keep these instructions with the product at all times and review before each use.
• It is the responsibility of this product's owner to furnish the instructions to any person that borrows or
purchases the product.
• Inspect the product before use to ensure it is assembled properly and all parts are in safe working
order and free of defects.
• Never modify this product in any way.
• All circumstances cannot be addressed in these instructions. Please use common sense and practice
general safety measurements when using this product.
•
Parts and/or instructions are subject to change without notice.

Safety

• Before using the ramps ensure other persons are clear of the vehicle and the ramps.
• Ensure that the ramps are free from damage before use.
•
Do not exceed the rated weight capacity of 60,000 lbs maximum axle capacity.
•
Do not use with tires that exceed the width of the ramp.
•
Use only a single pair of wheel ramps at the front or rear; do not use two ramps on one side of the
vehicle.
• Only use on dry, level, hard surfaces. Do not use if tires are wet.
• Position the ramps in line with the wheels, with the steering wheel pointed straight and the incline
against the tire tread.
• Drive slowly and cautiously onto and off of the ramps. Never accelerate or brake suddenly.
• Another person, standing clear of the vehicle, should observe and guide the driver when using the
ramps.
• Do not disconnect brakes, engine, transmission components, drive train, drive shaft, universal joints,
or wheels while the vehicle is on the ramps.
•
Always chock tires that are in contact with the ground upon the vehicle being positioned on the
ramps.
• Place the vehicle transmission in Park, or the lowest gear for manual transmissions, and engage the
parking brake.
Rev. 03232020 RaceRamps.com Page 1 of 3