Download Print this page

Opus Athabasca Assembly Instructions

Easel

Advertisement

Quick Links

AthAbAscA EAsEL — ASSEMBLY INSTRUCTIONS
PARTS
(1) Center Slide Post Support
(2) Upper Cross Bar
(3) Ratchet Post & Rear Leg Unit
(4) Lower Cross Bar
(2)
(5)
(3)
HARDWARE
(A) Hex Wrench/Allen Key (1 pc)
(B) Bolt Adapters (6 pc, 2 on U-Shaped Bar)
(C) Metal guard (2 pc)
(D) Large Screws (6 pc)
(E) Medium Screws (2 pc)
(F) Small Screws (2 pc)
(G) Long Bolts (2 pc)
(H) Short Bolts (2 pc)
(I) Long Bolts with springs (2 pc, in U-Shaped Bar)
(5) Side Legs
(6) Center Slide Post
(7) Top Canvas Holder
(8) Canvas Brush Tray
(9) U-shaped Bar
(1)
(5)
(4)
Page 1
YOU WILL ALSO NEED:
Phillips Screwdrivers (+) 2 sizes
Slot (Flat Head) Screwdriver (–)
(9)
(B)x6
(I)x2 (G)x2 (H)x2 (D)x6 (E)x2 (F)x2
(7)
(6)
(8)
(A)x1
(C)x2

Advertisement

loading
Need help?

Need help?

Do you have a question about the Athabasca and is the answer not in the manual?

Questions and answers

Summary of Contents for Opus Athabasca

  • Page 1 AthAbAscA EAsEL — ASSEMBLY INSTRUCTIONS PARTS YOU WILL ALSO NEED: (1) Center Slide Post Support (5) Side Legs Phillips Screwdrivers (+) 2 sizes (2) Upper Cross Bar (6) Center Slide Post Slot (Flat Head) Screwdriver (–) (3) Ratchet Post & Rear Leg Unit...
  • Page 2 AthAbAscA EAsEL — ASSEMBLY INSTRUCTIONS Assembling The Support Frame: Tip: We recommend assembling the easel entirely before tightening all of your hardware. Note: To make assembly easy, the wood parts have pre-drilled holes for all the screws, bolts and bolt adapters.
  • Page 3 AthAbAscA EAsEL — ASSEMBLY INSTRUCTIONS underneath the holes to keep the (B) Adapter in place. Put the (G) Long Bolts into the aligning holes on the sides of the (5) Side Legs. Use your (–) Slot Screwdriver to turn the (B) Adapters so that the slot lines up with the direction of the (G) Bolts.
  • Page 4 AthAbAscA EAsEL — ASSEMBLY INSTRUCTIONS Putting it all together: 9. Just like the for the (7) Top Canvas Bevel Holder, place the last (C) Metal Guard in the flared in channel of the (1) Center Slide Post Support. Then feed the flared in...