Wenger Class Piano Workstation Assembly Instructions Manual

Hide thumbs

Table Of Contents

Contents

Important User Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Required Tools. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Visit the Class Piano Workstation web page at wengercorp.com for more information.

Note: Please read and understand these instructions before starting the assembly.

Note: If you need additional information, contact Wenger Corporation using the information below.

©Wenger Corporation 2020

Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448

USA: (800) 4WENGER (493-6437) • Worldwide: +1-507-455-4100 • wengercorp.com

Class Piano Workstation

Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Printed in USA 2020-04

Assembly Instructions

Part #222E135-03

Table of Contents

Need help?

Do you have a question about the Class Piano Workstation and is the answer not in the manual?

Questions and answers

Summary of Contents for Wenger Class Piano Workstation

Page 1 Parts List ..........3 Visit the Class Piano Workstation web page at wengercorp.com for more information.
Page 2 Wenger Corporation. Wenger Corporation does not assume any responsibility for any errors that may appear in these instructions. In no event will Wenger Corporation be liable for technical or editorial omissions made herein, nor for direct, indirect, special, incidental, or consequential damages resulting from the use or defect of these instructions.
Page 3 Required Tools The following tools are required for assembly. Phillips head screwdriver • 4 mm hex wrench (supplied) if installing on a 76-key piano • Parts List Item Qty Description Workstation Desk Suction Cup Wire Grommet Power Strip Plastic Rear Cover #8-32 x 3/4"...
Page 4 Assembly 1. Screw eight suction cups (2) into the inserts on the bottom side of the workstation desk (1). Tighten securely. Suction Workstation Desk 2. Insert two wire grommets (2) into the slots on the top side of the workstation desk. Wire Grommet...
Page 5 Assembly (continued) The Class Piano Workstation is shipped to fit on top of a 88-key digital piano. STOP To fit on top of a smaller 76-key digital piano, the end support panels can be moved in. To move the end support panels, follow the step below before proceeding.
Page 6 Assembly (continued) Set the workstation desk to fit on top of the piano as shown. Press down firmly to secure the suction cups...
Page 7 Assembly (continued) 5. Attach the power strip (4) at the back side of the workstation desk under the desk surface using the included hardware. Wires, cords and cables can all be fed through the wire grommets. Feed wires, cords and cables Power Strip...
Page 8 Assembly (continued) 7. Attach the plastic rear cover (5) to the pilot holes at the back side of the workstation desk using four #8-32 x 3/4" Machine Screws (6). #8-32 x 3/4" Machine Screw Rear Cover Slide the music holder (7) over the front edge of the upper desk surface as shown. Music Holder...