Advertisement
Basic Instructions to be used with the Cupholder Accessory for Flex
For othe component information, refer to the Flex TechBridge Owner's Manual 236A153.
Parts List
Item Qty Description
1
1
Cupholder
2
1
Bridge Clip
3
2
Machine Screw, #10-24 x 5/8"
Note: Please read and understand these instructions before assembling.
Note: If you need additional information, contact Wenger Corporation using the information below.
©Wenger Corporation 2019
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: (800) 4WENGER (493-6437) • Worldwide: +1-507-455-4100 • wengercorp.com
Cupholder
Accessory
1
Item Qty Description
4
2
5
2
Printed in USA 2019-10
Assembly Instructions
Cupholder Accessory
2
Nylon Lock Nut, #10-24
Flat Washer, 0.188 ID x 0.734 OD"
®
for Flex
TechBridge
TechBridge only!
®
3
4
Part #236A186-02
5
Advertisement
Table of Contents
Related Manuals for Wenger Cupholder
Summary of Contents for Wenger Cupholder
- Page 1 Flat Washer, 0.188 ID x 0.734 OD” Machine Screw, #10-24 x 5/8” Note: Please read and understand these instructions before assembling. Note: If you need additional information, contact Wenger Corporation using the information below. ©Wenger Corporation 2019 Printed in USA 2019-10 Part #236A186-02 Wenger Corporation, 555 Park Drive, P.O.
- Page 2 Assembly 1. Attach the cupholder (1) to the bridge clip (2) #10-24 x 5/8” Machine Screws using two #10-24 x 5/8” machine screws (3), two 0.188 ID x 0.734 OD flat washers (5) and two #10-24 nylon lock nuts (4) as shown.
Need help?
Do you have a question about the Cupholder and is the answer not in the manual?
Questions and answers