Wenger BACKSTAGE MAKEUP STATION Replacement

BACKSTAGE
Warning: Never replace a Backstage Makeup Station damaged mirror with the power cord
connected to a power source. Failure to observe this warning can result in electric
shock and serious injury.
Warning: Always wear non-slip work gloves and safety glasses when replacing a damaged
mirror. Failure to observe this warning can result in serious injury.
Mirror Removal
1. Using a cordless drill and a 1/8-inch drill bit, drill through the two blind rivets that hold the Mirror
Flange to the Base Plate.
2. Wearing work gloves, slide the broken mirror downward disengaging the Top Retaining Clips.
3. Lift the old or damaged mirror away from the Frame.
Warning: Dispose of the broken mirror in a safe manner. Failure to observe this warning can
result in Injury from sharp edges of broken glass.
Base Plate
Drill through the two
Blind Rivets with an
1/8-inch drill bit.

INSTALL NEW MIRROR

1. Place the new Mirror against the Frame with the Mirror Flange at the bottom and the top edge about
one-inch from the Top Retaining Clips.
2. Slide the new Mirror upward until the top edge of the Mirror engages the two Top Retaining Clips.
3. Using a Blind Rivet Tool, attach two 1/8-inch steel Blind Rivets to the two holes on the Mirror Flange
and the Base Plate.
©Wenger Corporation 2014
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: 800-4WENGER (493-6437) • Worldwide: 1-507-455-4100 • www.wengercorp.com
MAKEUP STATION MIRROR REPLACEMENT
®
Mirror
1/8-inch Blind Rivet
Base Plate
Top Retaining Clips
Mirror
Mirror Flange
Printed in USA 02/14
Slide the Mirror upward until top edge of the
Mirror engages the two Top Retaining Clips.
Part #187A165-04