Advertisement
7.2.5.
store device in a frost-free room (at least 5 °c).
8. troubleshooting
fault
cause
Pump does not work
no power supply
motor overheat due to high liquid
temperature
motor overheats due to blocked
ventilation slots
residual current device activated
motor defective
delivery rate too slow
Water shortage
not enough pressure
suction pipe not sealed
delivery rate too slow
suction height too high
filter blocked or soiled
check valve blocked
Water leak between motor and pump,
shaft sealing not sealed
Pump is blocked or defective
Air in the pump or suction pipe
Pressure switch faulty
suction pipe sucked in on the ground
Pump does not switch off
cut out pressure set too high
Pressure side unsealed
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
Weee regulations
dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic
Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way.
contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
WarrantY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
remedy
check power cable, plug, supply
eliminate cause of overheating (max. liquid temperature is 35°c)
eliminate cause of overheating
reset
contact dealer
ensure sufficient water supply
seal suction pipe, tighten screwed connections
observe maximum suction height 8mtr.
suction height must be deducted from the conveyance height.
clean or replace filter
clean or replace valve
contact dealer
clean pump with clean water and remove the cause of the
contamination
fill pump case with water.
for suction pipes with a check valve, fill the suction pipe with water
contact dealer
shorten or fasten suction pipe
use filter screen with check valve
contact dealer
sole uK distributor, sealey Group.
Kempson Way, Suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7AR
Original Language Version
01284 757500
01284 703534
WPB062S.V2| Issue 1 01/07/16
www.sealey.co.uk
Web
sales@sealey.co.uk
Advertisement
