Page 2
CAUTION – NEVER operate this equipment without approved RxAir filters correctly installed. WARNING – DO NOT operate in the presence of combustible or explosive gases or powders.
This manual is intended to provide information for the proper operation and use of the RXAIR 3000 air purifier. General maintenance instructions are contained in this manual. Additional information or assistance is available by contacting your authorized RxAir representative or by calling RxAir customer support. (800) 231-3248 or (972) 233-2777 1.1 Warnings and Precautions A warning is provided if there is reasonable evidence of an association of a serious personal hazard with the use of this device.
Observe all Precaution and Warning labels on the device. Never place fluids on the top surface of the device. Use only RxAir recommended accessories and parts with this device. When cleaning the surface of the unit, do not use excessive amounts of liquid.
As a general rule it is necessary to keep windows and doors closed for maximum effectiveness of the RxAir unit. The RxAir unit is easily utilized in any room where air cleansing is desired, such as restaurants, offices, classrooms, health care rooms, waiting rooms, and day care facilities.
RX3000 Manual & Operating Instructions 7/10 3. Controls and Indicators Switches Lighted Indicators Figure 1: Controls & Indicators Power Switch Press to turn the unit on or off. Blower Switch Press to alternately select Hi or Low blower speeds. On Indicator Illuminates when the unit power swtich is in the On position and the unit is plugged in.
RX3000 Manual & Operating Instructions 7/10 4. Operation The RxAir air purifier is easy to operate. Position the unit on a flat floor surface. Plug the flat end of the power supply cord into the inset located in the rear left...
RX3000 Manual & Operating Instructions 7/10 4.1 RX3000 Anatomy Unit serial # is located on this label. Fuse holder Capacitor Isolator switches UV ballast Blower assembly Unit batch # is located on this label Power receptacle UV lamp Power cord Filter retaining latch &...
RX3000 Manual & Operating Instructions 7/10 5. Exterior Cleaning and Filter and UV Bulb changes 5.1 Exterior cleaning TURN UNIT OFF AND UNPLUG FROM ELECTRICAL POWER. Do not use excessive moisture. Use a soft lint free cloth, dampened with any standard cleaner or disinfectant to wipe the exterior of the unit.
RxAir unit. Place old filter assembly in carton. Step 5: Grasp new filter assembly by the handle and insert into the RxAir unit, with care not to damage the filter seal, slide filter all the way forward. (Figure 3) Step 6: Grasp the flexible rubber T handles and pull up to engage clips on the filter assembly.
Follow your facility disposal protocols with consideration as to how the RXAir unit was used. Install the new bulb, taking special care to handle the bulb at each metal end;...
RX3000 Manual & Operating Instructions 7/10 5.4 Pre-Filter Installation Figure 6 below illustrates the Pre-Filter in position on the Pre-Filter Support Bars. Pre-Filter Support Bars Figure 6: Pre-Filter Support Bars Figure 7 below illustrates the Pre-Filter being installed. Ensure the end of the filter seats onto the support bars shown in Figure 6.
Unplug unit Contact your representative or RxAir Note: Always contact an authorized RxAir representative or distributor for service of any RxAir product. Call RxAir Customer Service for assistance in locating the nearest representative. (800) 231-3248 or (972) 233-2777...
RX3000 Manual & Operating Instructions 7/10 5.7 Fuse inspection/change procedure Rx3000 The fuse holder is mounted on the rear of the plastic cabinet, it is located just above the access door on the left hand side of the cabinet (see image below).
RX3000 Manual & Operating Instructions 7/10 6. Lockout/Tag-out & Decontamination Procedure If you need help, please contact customer service at 1-800-231-3248 6.1. Powering the unit “off” When the unit is running, switch the power button to the “off” position, located on the control panel.
6.5 Replacement of the Germicidal UV Bulb The Germicidal UV bulb installed in the RxAir 3000 is rated at a life cycle of 8000 hours. An infection control protocol should be established regarding the frequency of changing of a new bulb for service life. All uv bulbs lose a percentage of effectiveness through the life cycle.
Visit our web site or see brochure enclosed with your unit. Please contact an authorized RxAir representative or distributor for replacement filter assemblies and other RxAir accessories. Call RxAir Customer Service for assistance in locating the nearest representative. (800) 231-3248 or (972) 233-2777 8.
Specifications are subject to change without notice. 8.1 Limitations The number of room air changes per hour by the RxAir Air Purifier is dependent not only upon device performance but by any other environmental factors which can affect room air. These include but are not limited to central heat and air conditioning, windows, and doors.
RxAir option, at the factory or at an authorized RxAir distributor, any product which shall under normal use and service appear to the Company to have been defective in material or workmanship.
RX3000 Manual & Operating Instructions 7/10 8.4 RxAir’s Responsibility RxAir is responsible for reliability and performance of the equipment only if: Assembly operations, readjustments, modifications, updates, or repairs are carried out by persons authorized by RxAir. The electrical installation of the power system complies with products requirements and meets all applicable National Electrical Code specifications;...
RX3000 Manual & Operating Instructions 7/10 10. HEPA Module Filter Log Unit Serial Number___________ Manufacturer Part # SF3000 Filter Serial Install Date Changed by Filter Serial Install Date Changed Page 24 of 25...
RX3000 Manual & Operating Instructions 7/10 11. Pre-Filter Log Manufacturer Part # SPF3000 Install Date Changed Install Date Changed by Install Date Changed Page 25 of 25...
Need help?
Do you have a question about the RX3000 and is the answer not in the manual?
Questions and answers