Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Homegear XCHEF-1001
- Page 1 Wall Mounted Electric Fireplace 2KW AC 220-240V~ 50Hz 2000W Electric fireplace...
-
Page 2: Getting Started
PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY AND RETAIN FOR FUTURE REFERENCE Getting Started • Remove the fireplace from the box. • Remove all the packaging and place it inside the box and either store or dispose of safely. Package Contents •... -
Page 3: Safety Information
Safety Information WARNING: READ THE FOLLOWING SAFETY INFORMATION BEFORE USING THE FIREPLACE 1. This fireplace is hot when in use. To avoid burns, do not let bare skin touch any of the hot surfaces. Be aware that surfaces near the fireplace outlet or light bulbs can get extremely hot. 2. -
Page 4: Installation
Helpful Advice before Installation • Please retain all packaging until you have checked and counted all the parts and the contents of the Installation Components pack against the Package Content list. • The Installation Components pack contains small parts which should be kept away from young children and infants. - Page 5 • Note: Ensure the bracket is leveled, by using leveler while marking the positions of the holes • Drill holes with applicable drill bit. • Install the wall bracket using the plugs and screws provided. • Carefully lift up the fireplace ensuring the top rear panel of the fireplace engages with the wall bracket (see Fig.
-
Page 6: Safety Cut-Off
Instruction for use The fireplace can be operated either with the switches located on the top right hand side of the fireplace or with the supplied remote control. Manual Operation • This is done by operating the switches located at the top right hand side of the fire. -
Page 7: Light Bulb Replacement
Light Bulb Replacement Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are three bulbs under the log set : To avoid burns, allow at least 5 minutes for the light bulbs to cool down before touching the Warning bulbs Bulb Requirements... -
Page 8: Cleaning And Maintenance
Cleaning and Maintenance • Warning: Always disconnect from the power supply before cleaning the fireplace. • For general cleaning use a soft, clean duster. Never use harsh abrasives or cleaners. The glass screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners. Technical Specification •...
Need help?
Do you have a question about the XCHEF-1001 and is the answer not in the manual?
Questions and answers