Advertisement
1. Release each of the top harness straps to the max
1
3. Place the harness on your hips,
close the main buckle around your waist
and pull the to straps to tighten
3
9
NOTE: You can play with the spine height
during work by using the trigger
To Balance the weight between your shoulder and hips
www.ORCAbags.com
OR-
1
1
2
3
6. Connect the top aluminum ring to the front connection on your mixer case
NOTE: We recommend connecting it as far from your body as pissiable
6
7. Connect the bottom aluminum ring to the front or rear D ring on your mixer case
NOTE: We recomend conecting it as far from your body as possible
7
8
Sound Harness Setup
Top Harness
Spine
Waist Belt
4. Push the two round buckles
and rotate to put more pressure on your hips
4
8. Push the trigger to release the spine
9. Bend forward to enlarge the spine and move the waight to the hips,
then release the trigger to lock the spine in the desired position
10. Adjust the straps on the top harness.
These do not need to be tight - just comfortable
11. Tighten the straps on the waist belt.
These should to be tight in order
to distribute the weight to the hips
2. Pull out the round buckles
on the waist srtap
Then pull out each of the
straps to the max
2
5
5. You can disconnect the top buckle
and roll in the top strap
NOTE: This strap is used when
wearing the waist strap only
10
1
1
1
11
Advertisement
