Smart Mode - Acond J1-01 Instructions Manual

Operation instructions

SMART mode

Press the SMART button, the unit enters SMART mode(fuzzy logic operation) directly regardless of
the unit is on or off. In this mode, temperature and fan speed are automatically set based on the
actual room temperature.
Operation mode and temperature are determined by indoor temperature
Heat pump models
Indoor temperature
21℃ or below
21℃-23℃
23℃-26℃
Over 26℃
Cooling only models
Indoor temperature
23℃ or below
23℃-26℃
Over 26℃
SMART button is ineffective in SUPER mode.
Press MODE button cancel SMATR mode.
Note: Temperature, airflow and direction are controlled automatically in SMART mode.
However, For the on/off, you can choose from -2 to 2, for the inverter you can choose
from -7 to 7. if you still feel uncomfortable
What you can do in SMART mode
Your feeling
Uncomfortable
because of
unsuitable air
flow volume.
Uncomfortable
because of
unsuitable flow
direction.
CLOCK button
You can adjust the real time by pressing CLOCK button, then
using and
CLOCK button again the real time is set.
Operation mode
HEATING
FAN ONLY
DRY
COOLING
Operation mode
FAN ONLY
DRY
COOLING
button adjustment procedure
Indoor fan speed alternates among
High, Medium and Low each time this
FAN
button is pressed.
Press it once, the vertical adjustment
louver swings to change vertical airflow
direction. Press it again, swings stops.
SWING
For horizontal airflow direction, please
refer to the previous page for details.
buttons to get the correct time, press
Target temperature
22℃
Room temperature
decrease 2℃ after
operate for 3 minutes
26℃
Target temperature
Room temperature
decrease 2℃ after
operate for 3 minutes
26℃
5
ON
OFF
ON/OFF
MODE FAN
SWING SLEEP SUPER
SMART
IFEEL DIMMER
TIMER ON TIMER OFF CLOCK