Advertisement
Quick Links
Lock Instructions
MODEL: STL-HHS-BIO
OPEN:
Step 1: Twist key LEFT (counter-
clockwise) to open door
INSERT BATTERY:
Step 2: Pinch tabs together and slide out
battery compartment
Step 3: Insert a 9V battery into battery
compartment & slide battery compartment
back into place
CHANGE YOUR COMBINATION:
Step 4: Hold down button 1 until green
light turns on and lock beeps 2 times
Step 5: Enter your current 6 digit
combination - lock will beep 2 times
Factory default is 1-2-3-4-1-2
l
Step 6: Enter your new 6 digit
combination - lock will beep 3 times
Step 7: Reenter your new 6 digit
combination - lock will chime
Your new combination is now installed.
*If lock beeps 5 times, combination was not
installed successfully. Restart from Step 4.
IMPORTANT! Test your new combination
several times with the door open to ensure
new combination is properly set before
closing and locking safe.
RECORD NEW COMBINATION HERE:
BIOMETRIC SCANNER:
Step 8: Press ONCE (do NOT hold) biometric
scanner button - lock will beep 2 times/lock
light and finger scanner will illuminate green
Step 9: Position finger fully on biometric
scanner - hold until lock chimes
Fingerprint installed successfully.
*If lock beeps 5 times, lock light flashes red, and
fingerprint scanner stays green, fingerprint was not
installed successfully. Restart from Step 8.
1
2
3
4
Lock
Light
Step 1
Silent Mode
Switch
SILENT MODE:
Use switch next to interior light to turn
silent mode on or off.
BATTERY LIFE:
If you see a continuous red light on,
replace battery
OPERATING INFORMATION:
Lock will go into standby after 10
l
seconds of inactivity
Lock will freeze for 5 minutes after 5
l
wrong combination attempts
RESET LOCK:
Hold down biometric scanner button
l
until lock beeps 5 times
Lock will reset to factory
l
combination of 1-2-3-4-1-2 and
erase all registered fingerprints
Step 9
Scanner can register up to 31 fingerprints
Fingerprint
Scanner
Your Electronic
Lock is currently
set with the default
combination of:
1-2-3-4-1-2
Step 2
Step 3
Red Interior Light
Biometric
Scanner Button
Advertisement
Related Manuals for Stealth STL-HHS-BIO
Summary of Contents for Stealth STL-HHS-BIO
- Page 1 Light Scanner Your Electronic Lock is currently Lock Instructions set with the default combination of: MODEL: STL-HHS-BIO 1-2-3-4-1-2 OPEN: Step 1: Twist key LEFT (counter- clockwise) to open door INSERT BATTERY: Step 2: Pinch tabs together and slide out Step 1...
- Page 2 Handgun Hanger Safe Security Cable Instructions Unlocked Locked Key will only release while locked. Step 1: Wrap cable around a secure object and insert lock through the loop on the other end of the cable. Step 1 Step 2: Make sure bolt is in unlocked position.