Optic arts FLEX ACV2 Installation Manual

FLEX ACV2 INSTALLATION GUIDE
Warning - 120VAC Line Voltage Product
Please read entire guide prior to starting installation.
Safety and Warning
• Product is not field cuttable. Attempting to field cut product may result in electric shock and will
void the UL certification. Do not puncture, cut, shorten or splice strip light.
• Do not use if there is any damage to the strip light or AC cord insulation
• Installation must be carried out by a licensed electrician.
• All installations must be executed in accordance with local codes.
• Do not subject to continuous strip light flexing. Please observe bending diameter instruction of 4"
diameter to not damage the strip light.
• The installing contractor assumes all liability for the safety and code compliance of the installation.
• Optic Arts is not liable for any damages caused by improper wiring, circuit overloading, power
surges, poor system design or layout, negligence or excessive force to connections.
• Secure strip light using mounting brackets or mounting extrusion provided by Optic Arts. Do not
secure with staples, nails or any material that will pierce and/or damage the insulation. Doing so
will void the product warranty and may cause electric shock.
• Do not route the cord through walls, doors, windows, or any other like part of building structure.
• S.C.T. Junction Box cannot be recessed. Must be surface mount.
• Do not exceed 100' of armored cable between SCT module and small junction box.
• This product is intended for indoor use only. Do not mount in wet location areas.
• S.C.T. module/Rectifier can hold a charge up to 2 minutes. Allow 2 minutes for discharging and
the LED indicator light to turn off before cutting power prior to servicing.
WARNING! This product is not to be cut in
the field. Doing so will void the warranty, UL
certification and can result in electrical shock.
S.C.T. Module/Rectifier can hold a charge up
to 2 minutes. Allow 2 minutes for discharging
after cutting power prior to servicing.
Handle with care. Do not exceed bending
diameter as specified. Do not put excessive
stress on power feeds.
213.250.6069
info@opticarts.com
www.opticarts.com
DO NOT BEND LED STRIP
FURTHER THAN 4'' DIAMETER
DON'T DO THIS: DO THIS:
<4'' >4''