Want More Information?
Central Heating New Zealand Ltd
52 Pilkington Way, Christchurch
Ph: 0800 3571233
info@centralheating.co.nz
www.centralheating.co.nz
PDF
FAQ
1
CHRFS – LED/button indication
Output status LED's
– Output active
when lit.
Pairing/override
buttons
Power
status
Retaining Screw
Rev 1.0
2
Installing the CHRFS
• Using a small screwdriver,
slightly loosen the screw
located at the base of the
CHRFS. You can then carefully
separate the front panel from
the back plate.
• Position the CHRFS back plate
on the wall, fixing into place
using the screws provided.
• Terminate the cables to the
CHRFS as shown in the wiring
diagram (section 6).
• Mount the front panel onto
the back plate, tighten the
LED
retaining screw on the base.
• Switch on the power supply,
the power LED will illuminate.
3
Overriding the CHRFS outputs
To override an output on the CHRFS, simply press the override button once,
the output & LED will then be activated.
To override the output off, press the button once.
Model: CHRFS