Motion Pro 08-0684 Instructions

Motion Pro Digital Tire Gauge P/N 08-0684

Quick Use Instructions

Press the ON/OFF button to power-up gauge. The gauge will display current pressure,
pressure unit (Psi, Kpa, etc...) and battery condition indicator. Select the desired
pressure unit by pressing the FUNCTION button until the desired pressure is shown
at the bottom of the display. Choices are Psi, Kpa, Bar and Kgf/cm2 (Note: pressure
unit cannot be changed when gauge is in
hold
setting.)
The gauge is now ready to measure pressure. Connect the gauge to the tire valve,
the display will show the current tire pressure to the tenth (1/10) of a pound. You
may depress the black pressure release button on the front of the blue trapezoid
body to release excess pressure from the tire until you reach your desired pressure.
The gauge will continuously monitor the current pressure unless set to
(see below). After use of the gauge is complete it can either be turned off manually
to preserve maximum battery life or allowed to turn off automatically after the
programmed auto-off time has elapsed (see below for instructions on changing the
auto-off timer).
The backlight will shut down after 20 seconds to preserve battery life. The gauge will automatically zero for changes in
temperature or ambient pressure during use; however, the gauge can be manually zeroed anytime using the Manual Zero
procedure described below if desired.
Note: The gauge will not hold pressure once removed from the tire valve. However, if it is desired that the gauge does retain
a pressure reading, it can be set to
gauge is turned off or is allowed to auto-off.

Manual Zero

With the gauge not connected to a pressure source, ensure there is no pressure in the unit by pressing the release button.
With the unit turned "on" and
Release the FUNCTION button and
then flash, –End will momentarily be displayed, and the gauge display will return to
complete and the gauge is once again ready for use.
Cont Hold
Setting and
Note: Virtually all users will normally use the
to continuously monitor the current pressure; however,
maximum pressure reading will be retained on the display until gauge is turned off or is allowed to auto-off.
With the unit turned "on" and
Release the FUNCTION button.
mode is displayed. The selected mode will then flash, –End will momentarily be displayed, and the gauge display will return
0.0
to . The gauge is now ready for use.
HOLD
Note:
will be displayed at the base of the display when in
Cont
in (continuous) mode.
I08-0684
hold
mode. See below for details on the
hold
mode and the maximum pressure indicated will be retained on the display until

Additional Features

0.0
displayed, press and hold the FUNCTION button for 5 seconds until
-000
will be displayed. Immediately press the ON/OFF button and
Functions
Cont
0.0
displayed, press and hold the FUNCTION button for 5 seconds until
Cont Hold
and will alternately be displayed. Press the ON/OFF button when the desired
Cont. (See Reverse Side)
hold
(Continuous) mode for normal tire pressure readings allowing the gauge
Hold
mode may be desirable in certain applications where the
Hold
mode. That area of the display will be blank when
mode
0.0
. The manual zero process is now
- - 0 –
appears.
0000
will display,
- - 1 –
appears.
03/2018