Information: Simplicity Installation and Setup STRASSER WOODENWORKS Installing Vanities CAUTION! Remove Doors and Drawers Always remove drawers and doors from your cabinets during installation (see pages 6 and 8) and store them away from the work area. This will make your cabinets lighter, easier to move and position, and safer to handle.
Information: Simplicity Installation and Setup STRASSER WOODENWORKS Installing Medicine Cabinets CAUTION! Remove Doors Figure 2. Always remove the doors from your medicine cabinet during installation (see page 6) and store them away from the work area. This Crown will make your cabinet lighter, easier to move and position, and safer to handle.
Page 4
Information: Simplicity Installation and Setup STRASSER WOODENWORKS 3. Measure down X" and make a level horizontal line. Figure 3. The top edge of the Wall Mounting Bar will be at this line. See Figure 3. 4. Appropriately and securely attach the Wall Mounting X"...
Simplicity Installation and Setup STRASSER WOODENWORKS Installing Overjohns & Cubbies Installing Simplicity Overjohn or Cubby 1. Determine the desired location of the Cabinet Box before Crown is installed) and mark the wall at top center of the Cabinet Box. See Figure 1.
Information: Simplicity Installation and Setup STRASSER WOODENWORKS Changing door swing on Cubbies To change the door swing from left-opening to right-opening or vice versa, simple rotate the cabinet body 180 degrees and hang on your wall. Installing Mirrors Figure 1.
Information: Simplicity Installation and Setup STRASSER WOODENWORKS Working with Doors Removing and Re-installing Doors with 6-way Adjustable Hinges To remove doors, loosen screw indicated on both hinges of a door To re-install doors, simply reverse the removal process. Tighten screws at least 2 full turns.
Information: Simplicity Installation and Setup STRASSER WOODENWORKS Adjusting Door Face Alignment Adjusting door up & down Loosen indicated screws on both hinges to adjust door up/ down. Never adjust one hinge on a door without also adjusting the other hinge on that door.
Information: Simplicity Installation and Setup STRASSER WOODENWORKS Working with Drawers Removing and Re-installing Drawers To remove a drawer, open the drawer, reach under it and pull the release levers Release toward the drawer front. The drawer is Levers now released from the glides and you can toward you and upward to remove.
Information: Simplicity Installation and Setup STRASSER WOODENWORKS Installing Vanities with China Tops CAUTION! Remove Doors and Drawers Always remove drawers and doors from your cabinets during installation (see pages 6 and 8) and store them away from the work area.
Information: Simplicity Installation and Setup STRASSER WOODENWORKS Filler and Scribe Molding Scribe Used to trim out small gaps between cabinet & wall, and/or floor. Scribe is rounded on one edge for a softer look. Filler cut two lengths: Scribe for front and for 48"...
Need help?
Do you have a question about the Simplicity and is the answer not in the manual?
Questions and answers