Summary of Contents for Spectrum Oringal LX
- Page 1 Spectrum LX LED Light Therapy System User’s Manual Version: February 2017 SPECTRUM SCIENCE and BEAUTY www.spectrumsciencebeauty.com.au PH:1300 766 198...
-
Page 2: Chapter 1 - General
Thank you for purchasing the LED Skin Rejuvenation System (Spectrum LX) by Spectrum Science and Beauty. Every Spectrum LX has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during transport. -
Page 3: Technical Specification
1.2 Technical Specification Model: Spectrum Oringal LX LED Colors: Red(620nm-635nm), Blue(415nm-465nm), IR(825nm-835nm), Blue, Red, Red + IR Light Power: 0-10 Levels Red Max: 40mW Blue Max: 60mW IR Max: 40mW Light Frequency: 0-110 Hz Time: 1-60 Minutes Treatment Area: 50cm×20cm... -
Page 4: Chapter 2 - Installation
CHAPTER 2 - INSTALLATION The process of installation includes: Unpack the unit Assembly of its components and ensure that all connections are firmly in place. Attach the power supply Switch on the unit and test all functions of the system 2.1 Accessories/Parts a - Adjusting arm g - Electrical outlet... - Page 5 2.2 Installation Before unpacking the Spectrum LX make sure that the working environment conforms to the requirements of this section. Attach the wheels and support to the base of the main unit as shown below (fig 2.1). Then attach the treatment head to the main body as follows. The wire from the head attaches as shown (fig 2.2)
-
Page 6: Chapter 3 - Operation
CHAPTER 3 - OPERATION The Spectrum LX is extremely easy to use. A – Time adjust up and down + time display B – Start and Pause button C – Light frequency display and up and down adjustment D - Light intensity display and up and down adjustment... -
Page 7: Treatment Procedure
3.1 Before and after the treatment Remove all Jewelry from the client. It is necessary to set different energy levels during the treatment procedure according to the customer’s acceptance levels. Aftercare instructions given by the clinician must be followed for best result. Table 3.2- Treatment protocol of LED/ Time suggestion TREATMENT LED COLOUR... -
Page 8: Chapter 4 - Maintenance
CHAPTER 4 - MAINTENANCE Turn off power supply after treatments; pull out power cord if you are not using the machine. Avoid damage to the LED’s. Clean the LED head constantly, turn off power supply and ensure machine has cooled down before cleaning.