Advertisement
D Installation of the Antenna
Feed the cables and thread through the hole. Position the antenna over the hole and press down onto
the panel with pressure. A plastic washer with a slot for cable routing is added first followed by a split
nut(M20). These provide options for vertical or horizontal cable routing. Secure the antenna in place by
attaching the nut from the underside of the panel, only a final tighten by spanner is required.
Recommended Mounting Torque: 5N-m
E Routing and Connection of the Cables
The Cables supplied are RG-174 for the GNSS, AM/FM and TETRA feeds and 1.5DS for the 5G/4G and Wi-Fi
MIMO feeds. A power cable, colored red, is also supplied for powering the AM/FM. The heatshrink will
denote which cable is which for ease of installation. Connect each individual connector to the correct port
of the device, if any cable is unused please fit a 50Ω terminator to the individual connection.
G Notices
Caution
To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules, antennas used with this device must be installed
to provide a separation distance of at least 20 cm from all persons to satisfy RF exposure compliance.
Warning
Do not Operate the transmitter when someone is within 20 cm of the antenna.
Do not operate the equipment in an explosive atmosphere.
European Waste Electronic Equipment Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled do not throw them away into standard waste.
Directive 2014/53/EU Radio Equipment Directive (RED)
Harmonised Standards and References:
EN 301 489-1 (V2.2.1): ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical
requirements. Referencing CENELEC EN 55032 Class B.
Waiver: This document represents information compiled by Taoglas to the best of our current knowledge. This is not
intended to be used as a representation or warranty of fitness of the products described for any particular purpose. This
document details guidelines for general information purposes only. When planning installations, always seek specialist
advice and ensure that the products are always installed by a properly qualified installer in accordance with applicable
regional laws and regulations.
Raptor III/IG-20-8-005-A
www.taoglas.com
Advertisement
