Qwik Tune QT-12 Instructions

1. Press ON.
2. Hold the insturment so the sound source is
within 4-8 inches (100-200mm) of the
"MIC" hole on the front of tuner.
3. Play any note. The note being tuned will
show at the top of the LCD meter.
4. While tuning, if the needle stops to the left of
"0" the pitch of the note is flat ( ). Adjust
instrument. Play note again. Repeat until the
meter needle lines up directly over the "0" on
the meter. The note is then in tune.
5. If the needle stops to the right of the "0" the
pitch of the note is sharp (#). Adjust instru-
ment. Play note again. Repeat until the meter
needle lines up directly over the "0" on the
meter.
6. The 3 LED's will light as follows:
• RED The note is -1 to -50 cents
below correct pitch.
• GREEN The note is in tune.
• RED The note is +1 to +50 cents
above correct pitch.
If the LED lights, follow instructions in no.
4 above.
QT-12
Instructions
• LCD • IN JACK
• ELECTRONIC • MICROPHONE
PITCH PIPE
• LEDs • NEEDLE
• ON/OFF