Table of Contents
Advertisement
Desktop Installation
1.
Attach the provided robber feet to the bottom of the switch
to keep the switch from slipping. The recommend position
has been square-marked.
2.
Install the switch on a level surface that can support the
weight of the unit and the relevant components.
3.
Plug the switch with the female end of the provided power
cord and plug the male end to the power outlet.
Rack-mount Installation
Rack mounting facilitate to an orderly installation when series
of networking devices being installed. The switch is supplied
with rack mounting brackets and screws for rack mounting the
unit.
Procedures to Rack-Mount the Switch in the rack:
1.
Disconnect all the cables from the switch before continuing.
2.
Place the unit the right way up on a hard, flat surface with
the front facing you.
3.
Locate a mounting bracket over the mounting holes on one
side of the unit.
4.
Insert the screws and fully tighten with a suitable
screwdriver.
5.
Repeat the two previous steps for the other side of the
unit.
6.
Insert the unit into the rack and secure with suitable
screws (optional).
7.
Reconnect all the cables.
5
Advertisement
Table of Contents
