Advertisement
Quick Links
Advertisement
Summary of Contents for BackYardCity Super Tube
- Page 1 Super Tube Spiral Slide Instructions...
- Page 2 Super Tube Spiral Slide 2 SECTIONS WITH OVER- LAPPING FLANGES 3 SECTIONS WITHOUT OVERLAPPING FLANGES 3-1/2” LAG SCREW W/WASHER 5/16” X 1” BOLT W/WASHERS AND LOCK NUT 5/16” X 3/4” BOLT W/WASHER *** THIS PRODUCT IS INTENDED FOR RESIDENTIAL USE ONLY.***...
- Page 3 STEP 1: ATTACHING ENTRANCE TUBE TO THE CORNER POSTS Take the FACE PLATE ENTRY piece labeled #1 and place it lush to the corner posts, so that the bottom of the large circular opening is lush to the TOP of the deck boards. Fasten the FACE PLATE ENTRY to the corner posts with 3-1/2”...
- Page 4 STEP 2: ASSEMBLING THE FIRST CURVED SECTION Locate a top SLIDE SECTION (Labeled #2) with an overlapping lange and a bottom SLIDE SECTION (Labeled #3) without an overlapping lange. Fasten the top and bottom SLIDE SECTIONS together along the langes (ribs) with 5/16” x 1” hex bolts and 5/16” lock nuts. Use a washer on both sides of the lange (rib).
- Page 5 STEP 3: ATTACHING FIRST CURVED SECTION TO FACE PLATE ENTRY SECTION Now that the irst CURVED SECTION is assembled, raise it up to the FACE PLATE ENTRY SECTION with the RIB vertical and the CURVED SECTION facing down. The RIB in the CURVED SECTION will get ro- tated TWO holes to the RIGHT.
- Page 6 STEP 4: ASSEMBLING THE SECOND CURVED SECTION Locate a top SLIDE SECTION (Labeled #2) with an overlapping lange and a bottom SLIDE SECTION (Labeled #3) without an overlapping lange. Fasten the top and bottom SLIDE SECTIONS together along the langes (ribs) with 5/16” x 1” hex bolts and 5/16” lock nuts. Use a washer on both sides of the lange (rib).
- Page 7 STEP 5: ATTACHING SECOND CURVED SECTION TO FIRST CURVED SECTION Now that the second CURVED SECTION is assembled, raise it up to the irst CURVED SECTION aligning the RIBS in the sections. The CURVED SECTIONS should make a “U” shape at this point. Rotate the RIB in the second CURVED SECTION two holes to the LEFT.
- Page 8 STEP 6: EXIT SECTION ASSEMBLY Locate the top EXIT PIECE (Labeled #4 with large cutout section) and the bottom exit piece (Labeled #5 this is the only curved section remaining). Fasten the exit pieces along the ribs with 5/16” x 1” long bolts and nuts provided using a washer on both sides of the lange.
- Page 9 STEP 7: ATTACH FOOT STAND TO EXIT SECTION Locate the FOOT STAND PIECE. Rotate the FOOT STAND PIECE so that the there is one hole showing on the LEFT on the EXIT SECTION. Fasten the FOOT STAND PIECE to the EXIT SECTION with 5/16” x 3/4” long bolts and washers.
- Page 10 STEP 8: ATTACHING THE SECOND CURVED SECTION TO THE EXIT SECTION Now that the EXIT SECTION and FOOT STAND PIECE are assembled, raise the EXIT SECTION up to the second CURVED SECTION and align the holes in the langes of the second CURVED SECTION and the EXIT SECTION so that the foot rests squarely on the ground.
- Page 11 THIS IS THE COMPLETED SUPER TUBE ASSEMBLY...
Need help?
Do you have a question about the Super Tube and is the answer not in the manual?
Questions and answers