Advertisement
Approval ECE-R129
B ab y St y le U
36 C h a rles St ree t
_ K L t
,
\
s h ire LE 1 2 7 R J
. b
Si l e
LeIces e
t
,
• www.babystyle.co.uk
Y
U nited K ingdom
Oyst@r
Capsule
Child car seat
Instructions
Height: 40-83cm Weight 0-13kg
• +441509 816444
CD
For your child's safety
please read carefully
before use
Infant
-·-
--
ECE-1129_
Advertisement
Table of Contents
Summary of Contents for Oyster Capsule Infant
- Page 1 Oyst@r For your child's safety please read carefully before use Capsule Infant Child car seat Instructions Approval ECE-R129 Height: 40-83cm Weight 0-13kg -·- B ab y St y le U 36 C h a rles St ree t _ K L t s h ire LE 1 2 7 R J Si l e LeIces e...
- Page 2 This is an “i-Size” Enhanced Child Restraint System (car seat).It is approved to Regulation No.129, for use in, “i-Size compatible” vehicle seating positions as indicated by vehicle manufacturers in the vehicle users’manual. If in doubt, consult either the Enhanced Child Restraint System manufacturer or the retailer. Oyster Capsule Infant Isofix Isize Car Seat...
-
Page 3: Product Overview
FEATURES PRODUCT OVERVIEW This is an i-Size child car seat, ,commonly known as a baby carrier/baby car seat/ Infant carrier. This infant For ISOFIX installation: Make sure you read the car carrier can be used together with a stroller (check manufacturer’s handbook. - Page 4 This infant carrier not suitable for a car which is only equipped with 2 point safety belts. compatible vehicle seating positions as indicated by vehiclemanufacturers in the vehicle users’ manual.If in Do not use rearward-facing in seating positions where doubt, consult either the Enhanced Child Restraint System an active frontal airbag is installed.
- Page 5 USAGE USAGE 4.4 Adjust and use the Y-shaped belts 4.6 Adjust the length of support leg Press the button to adjust the length of support leg and make sure the bottom Loosen the Y-shaped belts To tighten the Y-shaped harness belts Support leg of the support leg touch the ground completely,to suitable for different height of The Y-shaped belts can be slackened...
- Page 6 USAGE USAGE The ISOFIX attachments can be adjusted to other positions to fit the different positions of ISOFIX anchorage points relative ti the vehicle seat. As the picture above shows (picture 1) pill up the ISOFIX adjusting lever found at the front of the base and the ISOFIX bars on eithe side of the base will eject to the longest position.
-
Page 7: Installation
INSTALLATION INSTALLATION WARNING: This child (seat) restraint must be installed rear facing. 5.1 This child seat can be installed with adult 3-point belt as an infant carrier module. Pass belt Step 1:Place the child seat on the car Step Diagonal belt diagonally through the belt seat rearward-facing and make sure Step 4: Keep the infant carrier in a stable position and place on the vehicle... -
Page 8: Maintenance And Cleaning
Distance from left to right of Quantity the seat (width)：439mm Height of the seat：701mm (Install with ISOFIX anchorages with support leg) Weight of the seat：11kg Instructions Safety Guidelines Model: Oyster Capsule Infant. NO: LB/BBC- 328i- en- 01A 11/12 Instructions Safety Guidelines...
Need help?
Do you have a question about the Capsule Infant and is the answer not in the manual?
Questions and answers