GardenJoy NW-10S Instructions

AUTO REWIND HOSE REEL NW-10S / NW-15S / NW-20S / NW-30S

LOCATION


Find a suitable position to install your Retractable Hose Reel

Please take the following into account;
- The structure you mount the unit on must be of solid and sound construction,
which will not be upended when extending the unit.
- The unit must be able to rotate 180 degrees.
- Ensure that there are no obstacles in the immediate surroundings that will
prevent the hose to be extended.
- Mount the unit at a convenient height.
- Mount the unit no further from the water source as what the connecting hose
will allow.
- Should your garden exceed double the maximum length of the extended hose try
to place the unit in the center.
- Mount the unit in such a position that it is not subjected to extreme conditions
such as direct sun light, extreme heat or cold.

The unit is supplied with two mounting brackets, consider the following;
- Use one in the front and the other at the back of the dwelling to ensure optimum
use.
- Install multiple fixed source points if your furthest point exceeds more than
double the maximum extended length – or install a second unit.

INSTALLATION


Tools required;
- Power Drill with suitable 8mm Drill Bit
- Hammer.
- No 10 Spanner or Adjustable Wrench.
- Pencil.
- Spirit Level.
- Safety equipment during installation – Eye and ear protection and suitable
gloves.

Installation.
- Place the mounting bracket against the wall, ensure that it is level and mark the
holes.
NOTE: The unit will always swivel to its lowest point if the bracket is not
mounted level.
- Drill all holes with an 8mm masonry drill bit, at least 70mm deep.
- Remove all the dust from the hole and insert the provided plugs.
- Mount the bracket with the provided M6 x 60 Coach Screws and washers. Take