ALDI Ferrex CQB180D-1 Original User Manual page 14

Safety
- Make sure that the ambient temperature in an enclosed
working environ ment does not exceed +25 °C to ensure that
the compressor continues to function properly when
continuously and completely filled with air.
- Only operate the compressor in well ventilated rooms.
- Do not spray water or flammable liquids on the compressor.
WARNING!
Risk of injury!
The compressor is under pressure during operation and in an
unvented state. Pressure may be released if the compressor is
damaged, connections have been separated or if unsuitable or
damaged lines are used. There is a risk of injury.
- A compressor must not be used if it exhibits defects that pose
a risk to the operators or third parties.
- Check the compressor for rust and damage before each use.
Never operate the compressor if it is damaged or deformed. If
you identify damage, contact our After Sales Support at the
service address indicated on the warranty card immediately.
- Do not separate any connections while the compressor is in a
pressurised state.
- Never create holes or welded seams on the compressor and
never change its shape.
- Make sure that the compressed air tank is always vented
before separating the connections, connecting or removing
pneumatic tools.
- Move the On/Off switch (pressure monitor) to the "0" (OFF)
position once the compressor has been switched off.
- Make sure that you only use pneumatic lines for compressed
air that are suitable for at least 150 % of the maximum
pressure produced by the compressor.
14