Maintenance And Cleaning; Troubleshooting; Wearing Parts - Half Off Ponds CleanSweep 1400 User Manual

Maintenance and cleaning

•
Switch the unit off with the switch and pull the power plug. Remove all hoses and the motor housing.
•
Thoroughly rinse the collection container.
•
Remove the foam filter and clean it with clear water.
•
Check the foam filter and, if damaged, replace it by an original CleanSweep foam filter.
•
Check sealing rings for damage and completeness.
•
If necessary, change the rubber seal in the drain valve.
•
Only use original CleanSweep filter bags.
Malfunctions
Trouble Shooting
The unit does not perform its suction function
The unit does not reach its full capacity
The collection container does not drain, the unit
switches off immediately following the drain pause
Low suction capacity

Wearing parts

Foam filters, valve rubber parts and filter bags are wearing parts and are, therefore, not covered by our warranty.
Storage
Empty out the collection container and clean the unit. Store in a dry, frost protected room, inaccessible to children.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
Cause
Drain hose incorrectly fitted.
Excessive height difference between water level and
unit.
Dirt has accumulated in the foam filter, in the suction
tube or in the suction hose.
Dirt has accumulated in the nonreturn valve at the
drain hose preventing it from closing properly.
The collection container cannot drain.
Collection container and drain hose are soiled.
The more tubes are used, the higher the tube
frictional resistance. The suction capacity reduces.
©2018 Half Off Ponds. All Rights Reserved
Remedy
The non-return valve must be located at the
free end of the drain hose.
We recommend to place the unit at a height
identical to the water level.
Remove dirt.
Remove dirt.
Lay the drain hose without kinks. Provide a
slight gravity for the drain hose. Once drained,
the container must be almost completely empty
Remove dirt.
How to improve the suction capacity:
Hold the suction tube as flat as possible.
7