Advertisement
Quick Links
Advertisement
Summary of Contents for RCRCM SPLIT
- Page 1 INSTRUCTION MANUAL...
- Page 2 Unpacking • Please unpack the plane carefully making sure that you have retrieved all of the small parts. • Don’t throw the box out until you are 100% sure it’s empty! • Check that all the parts are supplied. • If any are missing please contact your vendor immediately. Quantity Description Fuselage...
- Page 3 WING - Realize a groove to pass the rod on the servos supports provided in the kit. - Glue the servos supports flap and aileron if you use slim wing servos. - Glue the horns of aileron and flap. Pierce delicately spar control surface to increase gluing.
- Page 4 horns will be glued to the cyano or with a mixture of epoxy and silica. -Pass the cables through the holes planned. (To facilitate this step can make use of a piano wire) then solder the plugs. -You can also add hot glue around the socket, to secure the welds Before installing the servos, set the neutral for the aileron servos.
- Page 5 You can now set up the servos cover. The cover is here glued to double-sided tape...
- Page 6 The wings is now complete !!!
- Page 7 Take a latex glove, place it on the SPLIT nose. Fill a plastic cup with plaster and dip the Typhoon + nose. Once dry, remove the fuselage. The installation of the fuselage has no particular problem. Take the time to reflect on the servos used and their location.
- Page 8 - The v-tail joiners are then glued to the fuselage. Use the hardware provided by the ARF kit...fix the iron stick like you see in the picture and glue it using epoxy. -Solder the bronze ball to the iron stick end.
- Page 9 - Sand the fuselage tail to have the correct assembles between tails and fuselage...
Need help?
Do you have a question about the SPLIT and is the answer not in the manual?
Questions and answers