Advertisement

IMPORTANT: READ THESE INSTRUCTIONS AND ALL WARNINGS PRIOR TO USING THIS EQUIPMENT.
UNDERSTAND
ALL
REQUIREMENTS. FAILURE TO DO SO COULD CAUSE AN ACCIDENT RESULTING IN SERIOUS OR
FATAL INJURY AND/OR PERSONAL PROPERTY DAMAGE.
The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means,
but only by exercise of intelligence, care, and common sense. It is therefore essential to have personnel involved in the use
and operation of equipment who are careful, competent, trained, and qualified in the safe operation of this equipment and its
proper use when servicing motor vehicles and their components. Examples of hazards are dropping, tipping, or slipping of
motor vehicles or their components caused primarily by improperly securing loads, overloading, off-centered loads, use on
other than hard level surfaces, and using equipment for a purpose for which it was not designed.
The owner and / or operator shall study and understand the product and safety instructions before operating this equipment.
Safety information shall be emphasized and understood. If the operator is not fluent in English, the product and safety
instructions shall be read to and discussed with the operator in the operator's native language by the purchaser / owner or
his designee, making sure that the operator comprehends their contents. A copy of these instructions / warnings shall
be retained for future reference.
Visual inspection shall be made before each use of this equipment, checking for abnormal conditions, such as cracked
welds, leaks, damaged, loose or missing parts. This equipment shall be removed immediately from service if it is believed to
have been subjected to an abnormal or shock load, the equipment shall be inspected by a qualified repair facility. Owners
and / or operators should be aware that repair of this equipment may require specialized knowledge and facilities. It is
recommended that this equipment be inspected annually by a qualified repair facility. Defective parts, decals, safety labels
or signs should be replaced with Strongarm specified parts.
WARNING

SETUP

Inflate rear tires to a maximum of 25 psi.
Install the quick disconnect of your choice in the air valve. Connect the shop air line to the quick
disconnect.
These jacks are equipped with extendable arms that are secured to the jack by a bolt and nut provided.
Sometimes a lower starting lift height is required. The jacks are shipped with the saddle risers on the
arms at the highest position but can be turned upside down by removing the saddles and the bolt and
nut that secure the arms to the jack. Remove the extendable arms, rotate them upside down, insert
them back in the jack, secure them with the bolt and nut provided and put the saddles in the risers.
Your saddles are now located in the lowest lift position.
OPERATING
PROCEDURES,

INSPECTION

TM
PROFESSIONAL LIFTING
& SERVICE EQUIPMENT
SAFETY
WARNINGS
WARNING
AND
MAINTENANCE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 528 and is the answer not in the manual?

Questions and answers

Summary of Contents for Strongarm 528

  • Page 1 / or operators should be aware that repair of this equipment may require specialized knowledge and facilities. It is recommended that this equipment be inspected annually by a qualified repair facility. Defective parts, decals, safety labels or signs should be replaced with Strongarm specified parts. WARNING SETUP •...
  • Page 2 PROFESSIONAL LIFTING & SERVICE EQUIPMENT OPERATING INSTRUCTIONS - 528 OPERATING INSTRUCTIONS 1. Become familiar with the three position air valve. Pushing the air valve lever to the right will raise the saddles for lifting. When the air valve lever is released it will return to the center (or neutral) position.

Table of Contents