Advertisement
3.4
Inspect the underside of the motorcycle for suitable support points, bearing in mind the centre of gravity of the motorcycle and which
wheel is to be lifted from the ground.
3.5
Place the stand under the motorcycle in the approximate position required.
3.6
turn the handle clockwise to raise the stand until the platform is in contact with the underside of the motorcycle. Adjust the position of
the stand as necessary and proceed to raise the bike.
3.7
for additional security it is advisable to retain the motorcycle on the stand with suitable straps, especially if the motorcycle is
already raised from the ground on a motorcycle lift.
3.8
When work is complete, check under the stand to ensure that there are no obstructions and that it is safe to lower the unit.
3.9
When the stand is fully lowered, ensure that the bike is standing on its wheels and is supported in the upright position.
4. MainTEnanCE
4.1
When the stand is not in use, store it in the lowered position.
4.2
Keep the stand clean and wipe off any oil or grease. Lubricate all moving parts with oil.
4.3
Before each use check all parts. If any part of the stand is damaged or defective, remove the stand from service and take the
necessary action to remedy the problem.
dO nOT use the stand if it is believed to have been subjected to abnormal load or shock. Inspect and take appropriate action.
5. dECLaRaTiOn OF COnFORMiTY
MOTORCYCLE sCissOR sTand
Model: MC5908
2006/42/Ec Machinery Directive
93/68/EEc cE Marking Directive
declaration of Conformity
in conformity with the following standards and directives.
the construction file for this product is held by the Manufacturer and may be inspected, by a
national authority, upon request to Jack sealey Ltd.
signed by Mark sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Quality Machinery.
We, the sole importer into the uK, declare that the product listed here is
10th october 2008
Advertisement
