SPUR GEAR /SLIPPER CLUTCH INSTALLATION KB-61026 KB-61027 KB-61027 KB-61052 KB-61027 KB-61027 KB-61026 KB-61026 H002 KB-61026 Install the spur gear and slipper clutch as show. Tighten the lock nut with a cross wrench once installed. A) If there is too much slippery, please loosen it for smoother power delivery. B) For high grip performance, please tighten it for quicker throttle response.
Page 36
The Splash Water Resistant Brushed Speed Controller (ESC) (Item No.: E910,E920 and E930) Pull the trigger (on the radio controller) back as shown in the picture , ESC permitting motors to work and the car goes forwards. Push the trigger outwards to brake. TECHNICAL DATA: ...
Page 37
Throttle Calibration (Centre Point) Make sure the speed controller is OFF. Returning the TH.TRIM (on the radio controller) to Zero point, the trigger Press and hold SEL button, switching on the speed controller. reverts to Centre automatically. Keep holding SEL button for around 5-6 seconds even after the speed controller is switched on. Press and hold SEL button, and the red LED alternates with two flashes every LED becoming flashing regularly, the speed controller enters protection programming automatically.
Need help?
Do you have a question about the Quakewave and is the answer not in the manual?
Questions and answers