Advertisement
12. Mount the work light bracket to the end holes of the
light channels with 2 capscrews (5/16 x 3/4 in.), flat
washers, and locknuts (Fig. 3).
13. Plug the ROPS harness connectors into the appropriate
light connectors. The brown/white wire is for the front
lights; the blue wire is for the rear light.
14. Mount the light channels to the ROPS as instructed in
the wire harness Installation Instructions.
Schematic
15. Connect the positive (+) battery cable to the battery.
Operation
To operate the work lights, move the toggle switches to the
On position.
2
Advertisement
