Advertisement
MEMORY HANDSET
MANUAL
Wake:
To wake press any button.
Calibrate
PRESS/HOLD
or Reset:
GLP:
stands for Go to Lowest Position. This means your desk must be re-calibrated.
CON:
stands for Connection. One of the frame legs are not working properly. Unplug the device and plug it back in.
stands for HIT. This protects your desk against collisions that could lead to damage.
HIT:
if something hits your frame while it is raising or lowering, it will automatically stop and Memory Handset will read
OH:
stands for Overheat. This will show up if the desk has had two minutes of constant usage. To resolve, wait 15 minutes for
your desk to cool down.
OLU:
stands for Overload, this means there is too much weight on your frame. Either remove some weight or change the load
capacity on your frame in setting
Set
ADJUST to 1st preferred height
Preferred
PRESS
Heights:
Set Max
PRESS/HOLD
Height:
When desk raises to highest point (120 CM) RELEASE PRESS
Set Min
PRESS/HOLD
Height:
When desk reaches lowest point RELEASE PRESS
PRESS/HOLD
Set Max/Min
Load Capacity:
PRESS
PRESS/HOLD
Measurement
PRESS
Conversion:
PRESS
Collision
PRESS/HOLD
Sensitivity:
PRESS
Feel free to reach out with any questions, comments, or concerns.
We are always happy to help!
15 seconds
LED Display shows
PRESS
REPEAT steps for remaining settings.
15 seconds
RELEASE WHEN LED Display blinks PRESS/HOLD
15 seconds
RELEASE WHEN LED Display blinks PRESS/HOLD
20 seconds
LED Display will show
to exit or
PRESS
then
PRESS
20 seconds
LED Display will show
OR
to go from inches (1) and cm (0)
then
PRESS
OR
to choose a di erent (P) setting
20 seconds
LED Display will show
PRESS
OR
to adjust sensitivity (5-30)
Setting One
Setting Two
Setting Three
HOLD until Display shows
LED Display shows
LED Display shows
PRESS
ADJUST max/min load capacity using
OR
to choose a di erent (P) setting
PRESS
once to show
PRESS
to exit or
PRESS
twice to show
15 is standard, lower the number the more sensitive.
Menu
Up Arrow
LED Display
RELEASE then Display shows 60.
PRESS
www.standdesk.co/contact
Down Arrow
OR
Advertisement
Table of Contents
Summary of Contents for StandDesk MEMORY HANDSET
- Page 1 HIT: if something hits your frame while it is raising or lowering, it will automatically stop and Memory Handset will read stands for Overheat. This will show up if the desk has had two minutes of constant usage. To resolve, wait 15 minutes for your desk to cool down.
- Page 2 INITIALIZING YOUR STANDDESK YOU MUST INITIALIZE YOUR STANDDESK BEFORE USE! Press and hold the down arrow for 15-30 seconds. As you hold the button, the frame will go down to its lowest position, and then calibrate. PRESS PRESS AND HOLD...
Need help?
Do you have a question about the MEMORY HANDSET and is the answer not in the manual?
Questions and answers