3. Connect “Frame Ground” to Negative (-) terminal on second battery. Ensure all connections are tight. 4. If the APU option was included, this will also be operational by following the above steps. Batteries Pump Frame Jumper Power Ground www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Page 5
3. Tighten as necessary to engage locking nut. Batteries 1. Connect leads labeled “Pump Power” to Positive (+) terminal. 2. Connect leads labeled “Frame Ground” to Negative (-) terminal. Battery Pump Power Frame Ground www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Note: The toggle switch is preloaded toward the “Off” position, therefore the Heliporter will stop automatically when pressure is released. Never operate the pump switch unless the Twist Grip and Raise & Lower Lever are in the neutral position. www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Page 7
Heliporter slowly and full rotation will move the Heliporter at full speed of 2.5 mph . slowly Caution: When engaging the hydrostatic drive, rotate the twist grip www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Note: The toggle switch is preloaded toward the “Off” position, therefore the Heliporter will stop automatically when pressure is released. Never operate the pump switch unless the Twist Grip and Raise & Lower Lever are in the neutral position. www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Page 9
Heliporter ® CAUTION: Never take off or land over the www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Page 11
Amber: Battery Weak < 12.5 V Green: Full Charge/Power Connected Green Flashing: Battery ECO Mode Blue: Analysis stage Blue Flashing: Desulfating pulses are in process ® CAUTION: Do not operate Heliporter while charger is plugged in. www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Page 12
W - Service batteries with water G - Grease all zerk locations C - Charge batteries using provided charger H - Service hydraulic system with 10W30 motor oil Fig. 3 Fig. 4 www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
8. Grease all zerks, a minimum of twice yearly. The wheel bearings should be greased more often, as usage and environmental conditions dictate. (Fig. 2 & 4). 9. Replace the protective pads at lift contact points as necessary. www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
APU, simply plug the connector into the aircraft receptacle. Make sure APU is properly stowed when not in use and keep the cord from coming into contact with any moving parts. www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Paravion Technology, Inc. unless express prior authorization is granted; nor shall this warranty apply to any product subjected to misuse or accident unless proof is submitted to ® the satisfaction of Paravion Technology, Inc. that such misuse or accident was not a cause for the claimed defect. ®...
Page 17
2001 Airway Avenue Fort Collins, CO 80524 www.paravion.com Phone: (970) 224-3898 E-Mail: paravion@paravion.com Fax: (970) 224-3899...
Need help?
Do you have a question about the Heliporter H250 Series and is the answer not in the manual?
Questions and answers
Only one drive wheel driving not two