Clare Controls ClareOne CLR-C1-PIR Installation Sheet

ClareOne PIR Motion Sensor Installation Sheet
Part number: CLR-C1-PIR

Description

The ClareOne PIR Motion Sensor is designed to fit seamlessly
in the corner of the room or alongside a wall/door. When the
PIR senses motion it transmits an alarm notification to the
ClareOne panel.

Important safety instructions

Before you install this sensor, be sure to:
•
Read, keep, and follow all instructions.
•
Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
•
When there is a low battery, replace with a compatible
lithium ion battery.

Installation

Note: We recommend adding the motion sensor to the
ClareOne panel before installation. For adding a sensor, see
ClareOne User Guide (DOC ID 1871).
The motion sensor can be installed using the provided
Adhesive or screws.
Note: We recommend using the provided screws for
installation. This method is more secure than using adhesive
alone.
© 12FEB20 Clare Controls, LLC.
To install the motion sensor:
1. Select the desired position for the sensor.
Note: The sensor only detects motion within 3.28 ft. (1 m)
below it and installed at 6.88 ft. (2.1 m) having a range of
32.80 ft. (10 m).
Remove the sensor's battery pull tab.
2.
Add the sensor to the panel. See "Sensor Management,"
3.
ClareOne User Guide (DOC ID 1871).
Note: You must press the button on the side of the sensor
to pair the sensor to the panel.
4. Adhere the sensor to the wall using the provided screws or
adhesive.
Note: We recommend using the provided screws for
installation. This method is more secure than using
adhesive alone.

Screws

4.1.a Locate the bottom of the sensor (the slotted
flat end), and then use a screwdriver to remove
the casing's screw.
1 / 6
DOC ID – 1898 • Rev 02